L3 Technologies AISA1 Manuale Utente
Marine Systems
Aviation Recorders
Initial Issue
Dec. 01/06
165M0014-10
Page 3–17
Page 3–17
3.1.5.
PowerUp and Configuration
At this stage you should have the following steps completed:
F
Transponder installed and 10–28 Vdc power connected.
F
VHF antenna installed and connected to transponder.
F
GPS antenna installed and connected to transponder.
F
IEC data cable installed and connected to transponder and terminal block.
The next step in the installation of the AIS transponder involves setup and configura-
tion. A complete description of the interface and menu system is previously given in
Section 2. Figure 3–8 presents a view of the layout of the integral Minimum Key-
board Display. This display includes a backlit LCD screen and keypad which allows
the user to enter the required static and voyage related vessel data. A complete de-
scription of the user interface and menu system is presented in Section 2. The con-
figuration process is summarized below.
tion. A complete description of the interface and menu system is previously given in
Section 2. Figure 3–8 presents a view of the layout of the integral Minimum Key-
board Display. This display includes a backlit LCD screen and keypad which allows
the user to enter the required static and voyage related vessel data. A complete de-
scription of the user interface and menu system is presented in Section 2. The con-
figuration process is summarized below.
communications
Power/Dim
Status Light
Pilot Port
Display Window
STATUS
ON / OFF / DIM
Figure 3–8. AIS Transponder MKD
3.1.5.1
PowerUp the Transponder
The following procedure should be followed to carry out final setup and testing of the
AIS Transponder.
AIS Transponder.
(1) Rotate the POWER button clockwise to turn on the transponder.
(2) Check the STATUS light for a steady light to ensure power is supplied to unit.