Creative Labs AVPSB1280 Manuale Utente
This equipment has been tested and found to comply
with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and
receiver.
-- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV
technician for help.
with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and
receiver.
-- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV
technician for help.
THIS DEVICE COMPLIES WITH THE CANADIAN
ICES-003
CLASS B SPECIFICATION
ICES-003
CLASS B SPECIFICATION
CET APPAREIL EST CONFORME AVEC LE CIEM-003
DU
CANADA CLASSE B SPÉCIFICATION CAUTION:
Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment
ATTENTION:
Les changements ou modifications non expresslment
approuvls par la partie responsable de la conformitl
pourraient annuler l’autoritl de l’utilisateur i faire
Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment
ATTENTION:
Les changements ou modifications non expresslment
approuvls par la partie responsable de la conformitl
pourraient annuler l’autoritl de l’utilisateur i faire
fonctionner l’l quipement
This device has been designed to operate with the
antennas listed below, and having a maximum gain of
[5.5] dB.
Antennas not included in this list orhaving a gain
greater than [5.5] dB are strictly prohibited for use with
this device. The required antenna impedance is [50]
ohms.
(1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the
device.
To reduce potential radio interference to other users,
the antenna type and its gain should be so chosen that
the equivalent isotropically radiated power (e.i.r.p.) is
not more than that permitted for successful
communication.
This device has been designed to operate with the
antennas listed below, and having a maximum gain of
[5.5] dB.
Antennas not included in this list orhaving a gain
greater than [5.5] dB are strictly prohibited for use with
this device. The required antenna impedance is [50]
ohms.
(1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the
device.
To reduce potential radio interference to other users,
the antenna type and its gain should be so chosen that
the equivalent isotropically radiated power (e.i.r.p.) is
not more than that permitted for successful
communication.
FCC RF Exposure Warning
This equipment complies with FCC RF radiation
exposure limits set forth an uncontrolled environment.
This equipment should be installed and operated with a
minimum distance of 20 centimeters between the
radiator
and your body. This transmitter must not be co-located
or operationg in conjunction with any other antenna or
transmitter
This equipment complies with FCC RF radiation
exposure limits set forth an uncontrolled environment.
This equipment should be installed and operated with a
minimum distance of 20 centimeters between the
radiator
and your body. This transmitter must not be co-located
or operationg in conjunction with any other antenna or
transmitter
This device used DC 11V lithium battery(without
charger); Operation Frequency is 2412 MHz to
2464MHz;
Have 3 channels, and have 2 antenna(The 2 Antenna
can not work together ,only can work individually).
charger); Operation Frequency is 2412 MHz to
2464MHz;
Have 3 channels, and have 2 antenna(The 2 Antenna
can not work together ,only can work individually).