Creative Labs VNIVF0340 Manuale Utente

 

This product is intended for use with FCC/CE certifi ed computer equipment. Please check the equipment operating/ installation manual and/or with the equipment 

manufacturer to verify/confi rm if your equipment is suitable prior to the installation or use of the product.

 

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed 

to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not 
installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur 
in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the 
user is encouraged to try to correct the interference by one or more of the following measures:
   

•   Reorient or relocate the receiving antenna.

   

•   Increase the separation between the equipment and receiver.

   

•   Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

   

•   Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1 This device may not cause harmful interference, and
2 This device must accept any interference received, including interference that may cause undesired operation.

To comply with the limits of the Class B digital device, pursuant to Part 15 of the FCC Rules, this device must be install with computer equipment certifi ed to comply with 

Class B limits. This product was tested for FCC compliance under conditions that include the use of shielded ethernet cable with ferrite on both ends.
All cables used to connect to the computer and peripherals must be shielded and grounded. Operation with non-certifi ed computers or non-shielded cables may results in
interference to radio or television reception.

 

Any changes or modifi cations not expressly approved by the grantee of this device could void the user’s authority to operate the device.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any 
other antenna or transmitter. For body operation, inPerson has been tested and meets the FCC RF exposure guidelines when used directly against the body. Specifi c Absorption 
Rate, or SAR is a measurement of radio frequency energy. The FCC permits a maximum SAR value of 1.6 mW/g. The highest SAR value for this product when used on the body, as 
described in this user guide, is 0.138 mW/g.

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

 

This digital device does not exceed the Class B limits for radio noise emissions from digital apparatus as set out in the interference-causing 

equipment standard entitled “Digital Apparatus,” ICES-003 of the Department of Communications.
Cet appareil numerique respecte les limites de bruits radioelectriques applicables aux appareils numeriques de Classe B prescrites dans la norme sur le materiel brouilleur: 
“Appareils Numeriques,” NMB-003 edictee par le ministre des Communications.

MODIFICATION: 

Any changes or modifi cations not expressly approved by the grantee of this device could void the user’s authority to operate the device. Toute modifi cation non 

approuvée explicitement par le fournisseur de licence de l’appareil peut entraîner l’annulation du droit de l’utilisateur à utiliser l’appareil.