Hitec RCD Inc. FLASH8 Manuale Utente
How work the Power-down mode?
1. Turn of the power of FLASH 8 then Press and hold the back and menu button at the same time then go to the Menu screen.
2. Turn the menu button then go into the SPECTRA menu. Select the Yes after press the menu button on the Range check.
3. Check the minimum distance more than 30 meters between the Tx and Rx then make sure the Tx and Rx work normally in the Power-down
2. Turn the menu button then go into the SPECTRA menu. Select the Yes after press the menu button on the Range check.
3. Check the minimum distance more than 30 meters between the Tx and Rx then make sure the Tx and Rx work normally in the Power-down
time.
4. Press the menu button if you want to change to the Normal mode.
2-way communication wireless remote control system
Receivers of Hitec FLASH 8 and OPTIMA series built in the 2-way communication model to detect the voltage level automatically after Power on.
And there are GPS, temperature, oil flow and RPM sensors in 2-way communication product (However, OPIMA6 can not mount 2-way communication
Option sensor.)
If you want to get more new information please refer the Hitec web site. www.hitecrcd.co.kr
Option sensor.)
If you want to get more new information please refer the Hitec web site. www.hitecrcd.co.kr
Low Battery Warning
- The battery voltage is normal, there is no change in the module.
- The battery voltage is low, the alarm sounds. Please check the battery voltage immediately if you here a beep in flight.
- The battery voltage is low, the alarm sounds. Please check the battery voltage immediately if you here a beep in flight.
SPC System
You can enjoy this SPC system only in Hitec Products. This auxiliary power system will supply the battery power to the SPC directly so the receiver
can always keep stable status in emergency situation. The SPC can be supplied up to 35 volts directly from the power battery. Never supply the power
to the Main Battery terminal of Rx. This is a description about the auxiliary power system that to supply power to the SPC terminal of the OPTIMA
receiver. Usually almost Servos will burn if the Main Battery terminal is supplied 35 volts.
( Note – Some of the High voltage servos need 7.4 volts in Hitec Products. Therefore you need 4 cell Ni-MH or 2 cell Li-Po receiver batteries and
Rectifier device for setting. SPC System is applied partially to the Hitec 2-way communication wireless remote control system.
If you want to get more information about 2-way communication products, please refer the Hitec web site.
to the Main Battery terminal of Rx. This is a description about the auxiliary power system that to supply power to the SPC terminal of the OPTIMA
receiver. Usually almost Servos will burn if the Main Battery terminal is supplied 35 volts.
( Note – Some of the High voltage servos need 7.4 volts in Hitec Products. Therefore you need 4 cell Ni-MH or 2 cell Li-Po receiver batteries and
Rectifier device for setting. SPC System is applied partially to the Hitec 2-way communication wireless remote control system.
If you want to get more information about 2-way communication products, please refer the Hitec web site.