Hitec RCD Inc. RANGER2NA Manuale Utente

Manual for Hitec Ranger 2N 

 
Welcome to the exciting world of R/C Modeling 
 
Thank you for purchasing the Ranger 2N, two channel, AM radio system. The Ranger 2N is 
ergonomically designed using the finest components availible and engineered to provide years of 
trouble- free service. 
Look for the complete line of entry level, sport and competition quality Hitec radio systems, 
servos, receivers, speed controls and battery chargers at your favorite hobby dealer. 
 
 
 
Do a lay-out diagram of the 2N showing all the Features, switch positions and functions. 
 
 
 
 

 
Please read the following section carefully before attempting to install the Ranger 2Z system. 
 
BATTERY INSTALLATION 
  
1. 

The transmitter requires eight and the receiver battery pack needs four AA size batteries. 
These can be Alkaline or Ni-cad cells. If you choose to install Ni-cad batteries, the 
optional CG-25A Hitec overnight wall charger can be used to re-charge them.  

 
2. 

When loading the batteries make sure the receiver and transmitter switches are in the 
“off” position. 

 
3. 

Open the battery door in the back of the transmitter by squeezing the tab on the bottom of 
the battery door and lifting up. 

 
4. 

Load batteries into the appropriate slots, taking care to install according to the proper 
polarity.  

 
5. 

Replace the battery door and turn the power “on”. If the batteries are fresh and charged, 
the green L.E.D. will be lit. Should the battery power drop to an unacceptable level, the 
red L.E.D. will flash, warning the user of impending failure. At this point, replace the 
alkaline cells or charge the batteries if they are Ni-cads     

  

Show battery loading drawing to represent the 2N battery installation