Motorola Mobility LLC T6ZD1 Manuale Utente

Your wireless handheld portable telephone is a low power radio 
transmitter and receiver. When it is ON, it receives and also sends 
out radio frequency (RF) signals.

European and International agencies have set standards and 
recommendations for the protection of public exposure to RF 
electromagnetic energy.

• International Commission on Non-Ionizing Radiation 

Protection (ICNIRP) 1996

• Verband Deutscher Elektringenieure (VDE) DIN-0848

• Directives of the European Community, Directorate General V 

in Matters of Radio Frequency Electromagnetic Energy

• National Radiological Protection Board of the United 

Kingdom, GS 11, 1988

• American National Standards Institute (ANSI) IEEE.C95.1-1992

• National Council on Radiation Protection and Measurements 

(NCRP). Report 86

• Department of Health and Welfare Canada. Safety Code 6

These standards are based on extensive scientific review. For 
example, over 120 scientists, engineers and physicians from 
universities, government health agencies and industry reviewed 
the available body of research to develop the updated ANSI 
Standard.

The design of your phone complies with these standards when 
used normally.

Use only the supplied or approved replacement antenna. 
Unauthorised antennas, modifications or attachments could 
damage the phone and may violate FCC regulations.

Hold the phone as you would any other 

telephone with the antenna pointed up and over your shoulder.

 For your phone to operate most 

efficiently:

• Extend your antenna fully (if applicable).

• Do not touch the antenna unnecessarily when the phone is in 

use. Contact with the antenna affects call quality and may 
cause the phone to operate at a higher power level than 
otherwise needed.

leap_en.bk : safety.fm5  Page 9  Wednesday, February 24, 1999  4:21 PM