Scosche Industries DIYALM2 Manuale Utente
Scosche Industries
X3 Wireless Lighter Sensor D.I.Y. Alarm
1.
Including:
1 lighter shape wireless sensor (can detect door open, trunk open, glass broken & big shocking), 1 module, 2-pc transmitter
2.
Installation:
a.
Screw the siren in the hood and connect the siren red & black wires to battery +12 volt & ground each.
Please keep the siren a little downward to avoid the water goes in. Do not install the siren too near the engine or high
temperature area.
ATTN: 1. Keep the small black antenna wire straight & away from the steel as can to have longer range.
2. The X3 only suit for the vehicle that come with good sealing of door & trunk when closed.
b. Turn the switch on the lighter sensor to On position, then plug into the 12 volt lighter socket for charging when ignition key
is On.
3.
Operation:
(1) 1
st
(Big) Button of Transmitter: Arm/Disarm
a. Press this button once can arm the system (will chirp once) or disarm the system (will chirp twice or chirp 4 times if
triggered before).
Please close all the doors & trunk well before arm the system, otherwise the system will not be triggered.
The siren will sound 3 times 30 seconds for any door open/trunk open/ glass broker/ big shocking when armed.
Press this button once can stop the sounding if siren is triggered and system will still keep armed, must press button once
again to disarm the system.
Remark: The lighter sensor can be hided in the glove box or inside of car where still can detect the air flow when door of
trunk is open (when not in charging) that still can be triggered if all the doors & trunk closed well when armed.
b. Transmitter & Lighter Sensor Code-Learning:
Within the 8 seconds after connected the white wire(code learning wire) to ground once, trigger the lighter sensor (toward
the sensor blowing by mouth if sensor switch is on, or switch on the sensor from off) or press the transmitter button once
can learn the sensor or transmitter code into the siren. Will chirp once if 1
st
code is learned, chirp twice for 2
nd
code and so
on, max. total 4 sets code can be learned.
Suggest to learn all the lighter sensor & transmitter codes into the siren if to do the code-learning.
The code-learning will be end immediately after the last set 4
th
code learned.
ON
0FF