Polar Electro Oy R7 Manuale Utente
ENGLISH
This user manual contains instructions for Polar
WearLink®+ Bluetooth transmitter.
WearLink®+ Bluetooth transmitter.
Please follow the pictures on the front cover.
Transmitter Parts
1.
The electrode areas on the reverse side of
the strap detect heart rate. Picture A1.
the strap detect heart rate. Picture A1.
2.
The connector sends the heart rate signal
to the wrist unit. Picture A2.
to the wrist unit. Picture A2.
Wear the Transmitter
1.
Wet the electrode areas of the strap under
running water and make sure that they
are well moistened. Picture B1.
running water and make sure that they
are well moistened. Picture B1.
2.
Attach the connector to the strap. Adjust
the strap length to fit snugly and
comfortably. Picture B2.
the strap length to fit snugly and
comfortably. Picture B2.
3.
Tie the strap around your chest, just
below the chest muscles, and attach the
hook to the other end of the strap. Picture
B3.
below the chest muscles, and attach the
hook to the other end of the strap. Picture
B3.
4.
Check that the wet electrode areas are
firmly against your skin and that the Polar
logo of the connector is in a central,
upright position. Picture B4.
firmly against your skin and that the Polar
logo of the connector is in a central,
upright position. Picture B4.
Detach the transmitter connector from the
strap and rinse the strap under running water
after every use.
strap and rinse the strap under running water
after every use.
The Polar WearLink Bluetooth connector can
be used with specific apparel with built-in
soft textile electrodes. Wet the electrodes and
clip the connector onto the apparel without
the strap, with the Polar logo in an upright
position.
be used with specific apparel with built-in
soft textile electrodes. Wet the electrodes and
clip the connector onto the apparel without
the strap, with the Polar logo in an upright
position.
E N G L I S H
1