Garmin International Inc 02324 Manuale Utente
®
FUSION
®
A-Class Infotainment System
Installation Instructions
Important Safety Information
WARNING
See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
NOTICE
Failure to follow these cautions could result in damage to the
vehicle or poor product performance.
This device must be installed according to these instructions.
Disconnect the vehicle's power supply before beginning to install
This device must be installed according to these instructions.
Disconnect the vehicle's power supply before beginning to install
this product.
Before applying power to this product, make sure it has been
Before applying power to this product, make sure it has been
correctly grounded according to the installation instructions.
You must read all installation instructions before beginning the
You must read all installation instructions before beginning the
installation. If you experience difficulty during the installation,
contact FUSION Product Support.
Installing the Infotainment System
1
If necessary, remove the dashboard bezel around the stereo
or stereo installation location.
2
If necessary, remove the existing stereo or infotainment
system.
3
Insert the included bracket
À
into the dashboard
Á
.
4
Secure the bracket to the dashboard using screws (not
included) through the inner holes
Â
.
5
Connect the included wiring harnesses to the vehicle wiring
harness and other A/V connectors as needed.
You can consult the wiring diagrams to identify specific
You can consult the wiring diagrams to identify specific
connectors and wires (
).
6
Route all harnesses and other wiring through the opening in
the bracket, and make all necessary wiring connections to
the back of the infotainment system (
7
Insert the infotainment system
Ã
into the bracket.
8
Secure the infotainment system to the bracket and
dashboard using screws (not included) through the outer
holes
Ä
.
9
Install the included dashboard bezel around the infotainment
system.
Connector Identification
Item Connector
Notes
À
USB
This connector is compatible with the two
included USB cables.
Á
GPS
This port is for the included active GPS
antenna.
Â
AM/FM antenna
You may need the included antenna
connector adapter to connect the vehicle
antenna to the system.
Ã
Primary wiring
harness
This harness contains power and speaker
wiring.
Ä
Secondary wiring
harness
This harness contains additional audio/
video connectors.
Wiring Harnesses
Primary Wiring Harness
The primary wiring harness contains the main power and
speaker connections for the system. The harness connects
directly to the stereo and to the vehicle wiring harness without
modification. You can use this diagram to troubleshoot or to
address non-default installation requirements.
NOTE: The power and rear speaker wires in the wiring harness
NOTE: The power and rear speaker wires in the wiring harness
have inline connectors. These connectors can be used when
you need an alternative power source to power the infotainment
system, or when the vehicle ISO 10487 connector does not
connect to the rear speakers.
March 2016
Printed in Taiwan
190-02062-02_0A