Davis Instruments DWW6326 Manuale Utente
Preparing the Rain Collector
Page 9
4.
Check the Junction Board cable connections: SIM Sensor, SIM Power, Motor,
Temp/Hum Sensor, and Solar Power. Refer to the figure below and also to
the Junction Board Connections figure on page 7.
Temp/Hum Sensor, and Solar Power. Refer to the figure below and also to
the Junction Board Connections figure on page 7.
5.
Install the Junction Board Cover as show below. The Junction Board Cover
presses easily into place when you are installing it. To remove the cover,
press gently in on both sides to release the latches holding it in place.
presses easily into place when you are installing it. To remove the cover,
press gently in on both sides to release the latches holding it in place.
6.
Slide the two sections of the Radiation Shield completely together.
7.
Place the flat washers, lock washers and plastic wing nuts over the
threaded rods.
threaded rods.
8.
Finger-tighten the wing nuts until they hold the radiation shield plates
firmly in place.
firmly in place.
Preparing the Rain Collector
Refer to this section in your ISS Installation Manual.
Choosing a Site for the ISS
Refer to this section in your ISS Installation Manual.
SIM Sensor
Interface Ca
Cable Clamp
AC Power Adapter
Cable
(cabled models)
Solar Power
Cable
(wireless models)
SIM Power
Cable
(wireless mo
Temp/Hum
Sensor Cable
Junction Board Cable Connections
Junction Board Cover
Junction Board
Press in on Si
near latches
to Remove Cove
Junction Board Cover Installation