Davis Instruments DWW7614 Manuale Utente
Page 2
Wireless Repeater
Choosing a Location
✦
AC-Powered Repeaters
Install in a sheltered location, with access to an AC-power outlet. Posi-
tion between the transmitter and the receiver so as to minimize the num-
ber of walls and other obstacles between both the transmitter and the
repeater or the repeater and the receiver.
tion between the transmitter and the receiver so as to minimize the num-
ber of walls and other obstacles between both the transmitter and the
repeater or the repeater and the receiver.
✦
Solar-Powered Repeaters
Find an outdoor location between the transmitter and the receiver so as
to minimize range and obstructions. Position the solar panel such that it
will receive maximum exposure.
to minimize range and obstructions. Position the solar panel such that it
will receive maximum exposure.
Setting up the Repeater
The repeater is pre-set by the factory to listen for a transmitter whose ID code is
also set to the factory default. If you
also set to the factory default. If you
have not reset
the transmitter’s ID code
from the factory default, then your repeater should pick up its signal automati-
cally.
cally.
If you
have
changed the transmitter ID code to one of the 7 other optional dip
switch settings, you need to set the repeater to listen for that ID code. To do so,
first find your current transmitter setting in the following table:
first find your current transmitter setting in the following table:
Then, set your repeater to listen for that ID code by flipping the appropriate
SENSORLINK TX dip switch. For example, if your transmitter’s dip switches
are set to OFF, ON, OFF, then you would flip dip switch #3 on your repeater to
ON.
SENSORLINK TX dip switch. For example, if your transmitter’s dip switches
are set to OFF, ON, OFF, then you would flip dip switch #3 on your repeater to
ON.
Powering the Repeater
To apply power to the repeater, do the following:
✦
AC-Powered Repeaters
Plug the AC-power adapter into the jack marked POWER, and into an
AC-power outlet.
AC-power outlet.
✦
Solar-Powered Repeaters
Plug the solar power cord into the the jack marked POWER.
ID C
ODE
D
IP
S
WITCH
1
D
IP
S
WITCH
2
D
IP
S
WITCH
3
#1
(default)
off
off
off
#2
off
off
ON
#3
off
ON
off
#4
off
ON
ON
#5
ON
off
off
#6
ON
off
ON
#7
ON
ON
off
#8
ON
ON
ON