Davis Instruments DWW765Y Manuale Utente

10

The wireless repeater contains a DIP switch used to give the repeater a unique identifica-
tion. DIP switches #1, 2, and 3 on the repeater are used in the same way that DIP switches 
are used on all stations. 

Note: 

For single repeater installations, the repeater should remain on the default ID of A and should not 
be changed.

Verify that the repeater DIP switches are all in the down position or OFF.

The repeater has the default ID of A and communication testing can continue as planned. 
If any of the three switches are on in any combination, switch them off. Refer to the table 
marked “Repeater ID DIP Switch Positions” on page 13

Once the transmitter ID has been verified or changed for use with the wireless repeater, it 
is time to program the wireless repeater with the station ID information. To do this:

1. Have the repeater placed in an area where it is likely to receive the transmitter signal.

2. Open the wireless repeater box and locate the four-position Repeater ID DIP switch 

next to the eight-position transmitter ID switch at the bottom of the repeater board.

3. Turn the #4 test position to ON. This test switch enables the TX and STAT LEDs. 

They display light patterns based on the behavior of the wireless repeater and how it is 
receiving signals from the transmitter. 

4. Turn the Transmitter ID to ON for the desired station and make sure all the other trans-

mitter IDs are in the OFF position. The following graphic demonstrates the Transmit-