Indyme Solutions Inc CU5300 Manuale Utente
9
2. Capacity
The CU5300/5303W
• Supports a minimum of 4,000 wireless device capability (i.e., 0001 – 3999)
• Supports a minimum of 1,000 Ethernet inputs that are separated from the wireless addresses
• Supports a minimum of 60 minutes of audio storage
• Supports a minimum of 1,000 Ethernet inputs that are separated from the wireless addresses
• Supports a minimum of 60 minutes of audio storage
3. RF Output
The CU5300/5303W
• Frequency Range: 868.175 - 869.675 MHz and 918.1 – 923.0 MHz
• Modulation Type: 2-GMSK frequency hopping spread spectrum
• Antenna Type: Omni-Directional dipole, +2dBi maximum gain, RP-SMA connector
• Modulation Type: 2-GMSK frequency hopping spread spectrum
• Antenna Type: Omni-Directional dipole, +2dBi maximum gain, RP-SMA connector
4. Ethernet
The CU5300/5303W
• Supports a standard 802.3 10/100 Ethernet connection.
• Supports 802.3af and 802.3at
• Uses a standard RJ45 connector with indicator LEDs for troubleshooting.
• Appliance is able to accommodate fixed and DHCP IP addressing.
• Supports 802.3af and 802.3at
• Uses a standard RJ45 connector with indicator LEDs for troubleshooting.
• Appliance is able to accommodate fixed and DHCP IP addressing.
5. Universal Serial Bus (USB)
• Two (2) USB connections are available on the controller.
• The USB ports are secured to minimize risk exposure.
• The USB ports will be used for various system and variable updates only.
• The USB ports are secured to minimize risk exposure.
• The USB ports will be used for various system and variable updates only.
6. Audio Ports
Direct Audio 1
• Direct Audio 1 is typically used to connect to a Public Address (P.A.) system.
• Direct Audio 1 has Audio In, Audio Out, Busy In, and a seize out (same as the Direct Audio 1 port on
• Direct Audio 1 has Audio In, Audio Out, Busy In, and a seize out (same as the Direct Audio 1 port on
the CLX/CLT).
• Direct Audio 1 is a standard RJ45 with the same pinouts as current CU’s
• Direct Audio 1 has an Input and an Output allowing another audio source to be looped through the
• Direct Audio 1 has an Input and an Output allowing another audio source to be looped through the
appliance.
• The appliance is able to switch between the external audio source (Audio In) and the internal audio
output as needed.
• The powered down and default mode allows the audio to pass from Audio In to Audio Out.
• The appliance is able to monitor Audio In for busy status (VOX). This feature is selectable on/off.
• The appliance is able to monitor Audio In for busy status (VOX). This feature is selectable on/off.
Direct Audio 2
• Direct Audio 2 is typically used to connect to an Indyme PT transceiver.