Indyme Solutions Inc CB961 Manuale Utente
Technical Document
430735-01
Rev. F
Indyme Solutions, Inc. 8295 Aero Place San Diego, CA 92123 USA +1.858.268.0717 +1.800.829.6141
Page 1 of 5
CB961 Wireless Help Button
Programming and Installation Instructions
Overview
The CB961 is a member of the Global Solutions Family. Indyme GSF products
operate in the 800MHz – 900MHz frequency spectrum. The CB961 help button is
designed for use at various customer service locations. GSF help buttons
communicate with an Indyme GSF Access Point. GSF products are not compatible
with legacy Indyme infrastructure and devices.
The CB961 is a member of the Global Solutions Family. Indyme GSF products
operate in the 800MHz – 900MHz frequency spectrum. The CB961 help button is
designed for use at various customer service locations. GSF help buttons
communicate with an Indyme GSF Access Point. GSF products are not compatible
with legacy Indyme infrastructure and devices.
Hardware
(3) #6 x 3/4 Phillips screw
(3) #6 plastic wall anchor
Programming Parameters
GSF products MUST be properly programmed to establish communication.
Programming parameters MUST match your configuration. The default settings are for
testing purposes only and should not be used. Failure to properly program your help
button and access point will prevent your devices from working.
GSF help buttons have three primary programming parameters; Netcode, Address and Operating Mode. These
MUST be programmed in the correct order to establish communication and ensure proper operation. Identify the
parameters for your configuration before you begin programming.
Using the programming instructions below set the following parameters in order.
GSF products MUST be properly programmed to establish communication.
Programming parameters MUST match your configuration. The default settings are for
testing purposes only and should not be used. Failure to properly program your help
button and access point will prevent your devices from working.
GSF help buttons have three primary programming parameters; Netcode, Address and Operating Mode. These
MUST be programmed in the correct order to establish communication and ensure proper operation. Identify the
parameters for your configuration before you begin programming.
Using the programming instructions below set the following parameters in order.
Netcode – unique identification code for the installation environment.
Address – alarm number associated with a control unit alarm event.
Operating Mode – defines how the help button will respond when activated.
Programming a help button requires a series of button presses. The specific buttons vary by help button type.
On the CB961, SET is the “Press for Assistance” button and RESET is a small oval below the SET button. The
assurance LED is red and is located BEHIND the SET button. This LED will flash during programming to indicate
your progress.
Netcode
*00000001
Address
*0001
Operating Mode
*1
* Default parameters are for testing purposes only.
RESET