Indyme Solutions Inc TYPEA2 Manuale Utente
Technical Document
430715-03
Rev. G
Indyme Solutions, Inc.
8295 Aero Place San Diego, CA 92123 USA +1.858.268.0717 +1.800.829.6141Page
3 of 5
Menu-2: Learn Mode
Allows the help button to capture the Netcode from another GSF device; (help button or access point). All help
buttons and access points must have the same Netcode to communicate.
buttons and access points must have the same Netcode to communicate.
After entering the Programming Menu;
Press the SET button two times for Menu-2, RESET once to save.
The LED will flash twice to indicate Menu-2 was selected.
The LED will then begin flashing. ¼ second on, 1 second off. This indicates that the help button is
requesting a Netcode. When the help button receives a Netcode, it will flash the assurance LED rapidly for
approximately 3 seconds and then it will exit Menu-2. If no Netcode is received within 5 minutes, the help
button will exit Menu-2.
requesting a Netcode. When the help button receives a Netcode, it will flash the assurance LED rapidly for
approximately 3 seconds and then it will exit Menu-2. If no Netcode is received within 5 minutes, the help
button will exit Menu-2.
Menu-3: Operating Mode
Assigns the help button operating characteristics; timeout duration, RESET signal and number of active buttons.
Although set at the help button, the Operating Mode can be reset and overridden by the control unit. Operating
Modes will vary by help button type, below are the default modes for this help button.
Although set at the help button, the Operating Mode can be reset and overridden by the control unit. Operating
Modes will vary by help button type, below are the default modes for this help button.
After entering the Programming Menu;
Press the SET button three times for Menu-3, RESET once to save.
The assurance LED will flash three times to indicate Menu-3 was selected.
Press the SET button to select a Help button Operating Mode: <1, 2>, RESET once to save.
The assurance LED will flash to indicate the selected Operating Mode.
Mode 1 - Standard 8-min timeout, No Reset
Press any channel button to trigger the alarm state; the corresponding LED(s) will flash. The LED will
flash for 8 minutes, then extinguish with no reset sent. The RESET button will sent a reset signal for all
active channels.
flash for 8 minutes, then extinguish with no reset sent. The RESET button will sent a reset signal for all
active channels.
Mode 2 - Standard 30-sec timeout, No Reset
Press any channel button to trigger the alarm state; the corresponding LED(s) will flash. The LED will
flash for 30 seconds, then extinguish with no reset sent. The RESET button will sent a reset signal for
all active channels.
flash for 30 seconds, then extinguish with no reset sent. The RESET button will sent a reset signal for
all active channels.
Menu-7: Clone Mode
Allows the help button to broadcast the Netcode to other GSF help buttons. All help buttons and access points
must have the same Netcode to communicate.
must have the same Netcode to communicate.
After entering the Programming Menu;
Press the SET button seven times for Menu-7, RESET once to save.
The assurance LED will flash seven times to indicate Menu-7 was selected.
The assurance LED will now flash a cadence of 4-pause, 4-pause
͙ etc. The help button will stay in Clone
mode for 5-minutes or until the RESET button, is pressed.