Chamberlain Wireless Products Inc. PIR2 Manuale Utente

The PIR Motion Sensor only works with
Chamberlain's Wireless Pedestrian & Vehicle Alert
with Voice (Model RWV400R). The PIR Motion
Sensor can be used to monitor motion up to 30' away
and can transmit a signal up to 1000' away from the
Base Station (not included). The Passive Infra-Red
sensor detects movement of people and vehicles,
while allowing small animals to pass through
undetected. The PIR Motion Sensor has a built-in
microphone and speaker that allows for
communication between the Base Station and the
Sensor. When the PIR Motion Sensor detects
movement a signal is sent to the base station which
alerts the homeowner with sounds and lights. The
Alert can also remotely control an electrical device
near the PIR Motion Sensor like a light or a 
camera (See Advanced Features).

Passive Infra-Red (PIR) 

Motion Sensor

1

Swivel Bushing

Mounting Plate

Intercom Feature: When PIR Motion Sensor has
detected motion, the Base Station will allow you to
listen through the PIR Motion Sensor for 10 seconds.
If you wish to talk to the person on the other end,
hold down the Talk button and speak, releasing it to
hear.

Volume: Pressing the Volume button repeatedly will
cycle through volume levels.

Mute: To temporarily mute Base Station, hold the
Volume and Talk buttons down for three seconds. The
Base Station will reactivate after one hour, or by
pressing the Talk button.

Remote Button: If there is an accessory device
connected to the relay on the PIR Motion Sensor, it
can be activated by pressing the Remote button
within 30 seconds of the signal from the alert buzzer.

Battery: The AA Alkaline batteries (not provided) will
last up to 2 years depending on use (Lithium batteries
recommended for colder environments). If PIR Motion
Sensor batteries are low Base Station will emit three
high-pitch beeps every ten minutes. If Base Station
batteries are low it will emit two high-pitch beeps.

Clear Memory: Press and hold the Learn button on
the Base Station until 3 beeps are heard. If PIR
Motion Sensor signals while Learn button is pressed,
repeat the procedure.

Programming Additional PIR Motion Sensors:
Each Base Station can learn the code of up to 8 PIR
Motion Sensors, responding with multiple buzzes. To
program additional PIR Motion Sensors see Step 6.

On/Off: To turn Base Station OFF hold down the
Volume button until a beep is heard and light goes
out. To turn Base Station ON press the Talk button.

Volume Button

PIR Sensor/Test Light

Speaker

Talk
(Power - On)

Remote 
Activation 
Button

Learn
Button

Switch #1: Mute
Switch #2: Tone

AC Adapter

Relay Output
Contacts

1

2

ON

OFF

®

OFF

Buzzer Off

ON

Buzzer On (Default)

OFF

Long Buzz

ON

Short Buzz (Default)