Chamberlain Wireless Products Inc. PTE2 Manuale Utente

DSW 1

DSW 2

OFF

Step 1 & 2 must occur within 5 seconds of each other.

ACTIVATING A PUSH TO EXIT TO AN EXISTING MINIGAP

NETWORK

Step 1 & 2 must occur within 5 seconds of each other.

PUSH TO EXIT

- 2 -

- 3 -

GCU DIPSWITCH SETTINGS

GCU

CLEARING THE MEMORY

Step 1 & 2 must occur within 5 seconds of each other.

ACTIVATING A PUSH TO EXIT TO A GCU

Step 1 & 2 must occur within 5 seconds of each other.

ACTIVATING A PUSH TO EXIT TO AN EXISTING KEYPAD NETWORK

#2
#3
#4

USING THE PUSH TO EXIT

ACTIVATING A PUSH TO EXIT TO AN EXISTING GAP NETWORK

The Push Is Exit is designed to be activated into an existing Gate
Access Network.

Install 4 ‘AA’ batteries into the Push To Exit. Lithium are preferred in
cold climates.

1. Press the LEARN button on a Push To Exit.

2. On the Gate Access Panel (GAP),

Enter the Master Pin Number (for example):

Followed by:

The Push To Exit will respond with a beep indicating a successful
activation.

1 2 3 4

0 5

NOTE: If the GCU has already been activated to a Gate Access Panel (GAP),
Keypad, or MiniGAP, then the Push To Exit should also be activated to the GAP,
Keypad, or MiniGAP

1. Press the LEARN button on the GCU.

2. Press the LEARN button on the Push To Exit.

The Push To Exit will respond with a beep indicating a successful
activation.

The Push Is Exit is factory set to control GCU #1.

Simply press the button to exit.

Hold down the learn button until you hear the beep.

1. Press the LEARN button on the Push To Exit.

2. Press the LEARN button on the MiniGAP.

The Push To Exit will respond with a beep indicating a successful
activation.

1. Press the LEARN button on the Push To Exit.

2. Press the LEARN button on the Keypad.

The Push To Exit will respond with a beep indicating a successful
activation.

OPE2

Patents Pending

7/25/2007