HID Global Corporation SMARTID Manuale Utente
Page 10 of 19
February 13, 2008
© 2008 HID Global Corporation. All rights reserved.
SmartID Proximity Reader - 8030-901, Rev A.0
5 Installation Instructions
1.
Drill two holes for mounting the reader (see Figure 1 Mullion Mounting, page
7). Do not mount readers less than 20 cm (7.87 in) from each other. Make
sure that enough room to connect the cable is allowed. Protect the cable
against sharp edges and any damage from chaffing.
7). Do not mount readers less than 20 cm (7.87 in) from each other. Make
sure that enough room to connect the cable is allowed. Protect the cable
against sharp edges and any damage from chaffing.
2.
Remove the Terminal Connector 8 pin from the back of the reader. Use a
small flat head screwdriver to loosen all terminals. The end of the cable
should be prepared by cutting it back to expose the wires and each end
should be twisted to eliminate any loose or frayed wires.
small flat head screwdriver to loosen all terminals. The end of the cable
should be prepared by cutting it back to expose the wires and each end
should be twisted to eliminate any loose or frayed wires.
3.
Connect the wires to the reader inline with the connector assignments. Wire
ends outside the shielding and optional permanent LED links should be kept
as short as possible. Twist the connector a few times to twine the wire ends
avoiding differential mode interference on the data lines.
ends outside the shielding and optional permanent LED links should be kept
as short as possible. Twist the connector a few times to twine the wire ends
avoiding differential mode interference on the data lines.
Note: Wires at the connector must be kept as short as possible: long, unshielded
connections will reduce the sensitivity of the reader.
4.
After wiring the reader and the Host system, the reader is ready to be
tested. Apply power and present a card to the reader. The green LED
should flash and the buzzer should beep indicating a read. If the Host
system is connected to the red and green LED inputs these should follow
the functionality of the Host system.
tested. Apply power and present a card to the reader. The green LED
should flash and the buzzer should beep indicating a read. If the Host
system is connected to the red and green LED inputs these should follow
the functionality of the Host system.
5.
Secure the reader using the appropriate screws. Mount the black cover
(sticker) and mount the cap over the mounting hole.
(sticker) and mount the cap over the mounting hole.
February 13, 2008
© 2008 HID Global Corporation. All rights rese
SmartID Proximity Reader - 8030-901, Rev A.0
5.1 Wall Mounting Drawing (All Mode
The drawing dimensions are in millimeters. 1 mm equals 0.039 inch
Figure 1 Mullion Mounting