HID Global Corporation 1050 Manuale Utente

Page 2

1. After unpacking, check to make sure that you have all of the equipment listed in the System
    Equipment List on page 1. Make sure your PC is off.

2. Connect the HID ProxProgrammer DB9 cable to the selected Serial Port on the target PC.
   (The HID Field Programmer software uses COM1 as a default setting.) To change the COM port

setting, refer to the section: Selecting a COM Port, pg. 5.

3. Connect the power supply to the HID ProxProgrammer. The power jack is located on the back of

the HID ProxProgrammer.

4. When you plug the power supply into the wall, you will hear a single Beep that indicates the HID

Field Programmer is on. The LED on the front of the unit will flash green once then turn red and
remain on after the power is supplied to the unit.

5.  Boot up your PC.

1. Insert the HID ProxProgrammer Install CD into the disk drive. From the CD directory copy the

NETSETUP folder to your desktop.

2. Open the NETSETUP folder. Execute the SETUP.EXE program. This will begin the installation.

3. Setup will initialize, ask a few questions, and then complete the setup. A program group entitled

HID will be created and accessible from the START menu.

4. After the programmer software is successfully installed, proceed to the Customer Configuration.

Customer Configuration.