HID Global Corporation 1351B Manuale Utente

www.hidcorp.com

An ASSA ABLOY Group company

HID Global (California, USA)
support: tech@hidcorp.com
main: (949) 598-1600
support: 1-800-237-7769
fax number: (949) 598-1690

HID Corporation, Ltd. (Haverhill, UK)
support: eusupport@hidcorp.com
main: +44 (0) 1440 714 850
support: +44 (0) 1440 711 822
fax number: +44 (0) 1440 714 840

HID Asia Pacific Ltd. (Hong Kong)
support: asiasupport@hidcorp.com
main: (852) 3160 9800
support: (852) 3160 9802
fax number: (852) 3160 4809

Switch and Battery Replacement

Figure 2 Power

Switch

Figure 3 Replacing Batteries

1. When replacing the batteries use only Panasonic BR2330 batteries (two required). These are

available from Panasonic or a battery distributor and are not available retail.

Note: Although CR-type batteries (CR2330) are available in the same size and voltage, they are not
compatible with the ProxPass II. CR2330 batteries are not rated for the extreme temperatures which
are typical inside vehicle windshields.

2. Remove unit from vehicle windshield.

3. Slide the switch to the OFF (O) position, see Figure 2 Power Switch.

4. Remove the two battery door screws on the back of the unit (using a #0 or #1 slotted or Phillips tipped

screwdriver) and then open the door, see Figure 3 Replacing Batteries.

5. Remove and replace the old batteries. Use caution to orient the + terminals of the batteries outward –

toward the battery contacts also marked +.

6. Close the battery door and tighten the cover screws.

7. Reinstall the unit on the vehicle windshield.

8. Slide the switch to the ON (I) position.

CAUTION: Do not park a vehicle with a ProxPass II installed within 15 feet of a MaxiProx, as the tags will
continuously attempt to communicate with the reader, which reduces the battery life.

FCC Compliance Statement: This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.