HID Global Corporation X001800C Manuale Utente
©
2010
HID
Global
Corporation
All
rights
reserved
Selecting the Advanced Settings tab
Setting
Option
Flipper Lam Height
Offset
Offset
This is a calibration driven value and should not be
adjusted. If the Flipper unit is replaced and has not been
calibrated this value may need to be adjusted.
adjusted. If the Flipper unit is replaced and has not been
calibrated this value may need to be adjusted.
(Note: This is factory set and should not be changed
unless directed by a technician.)
unless directed by a technician.)
Mag HI-Co Voltage Offset
This option changes the voltage going the magnetic head.
(Note: This is factory set and should not be changed
unless directed by a technician.)
(Note: This is factory set and should not be changed
unless directed by a technician.)
Mag Lo-Co Voltage
Offset
Offset
This option changes the voltage going the magnetic head.
(Note: This is factory set and should not be changed
unless directed by a technician.)
(Note: This is factory set and should not be changed
unless directed by a technician.)
OLED Contrast
(display contrast)
Use this option to increase or decrease the contrast of the
printer OLED (if applicable).
printer OLED (if applicable).
Resin Heat Adjust
Use this adjustment for Black resin text and barcodes
appear faded or too light/dark.
appear faded or too light/dark.
Adjust the Resin Heat, Front (K) or the Resin Head, Back
(K) as needed.
(K) as needed.
• Move the slider to the left to cause less heat to be
used in the printing process, causing resin images to
be lighter or less saturated.
be lighter or less saturated.
OR
• Move the slider to the right to (a) cause more heat to
be used or (b) cause the resin image to be darker or
more saturated.
more saturated.
(Note: This control can be helpful for fine-tuning the
transfer of resin text and bar codes.)
transfer of resin text and bar codes.)
DTC4500 Card Printer/Encoder User Guide
43