HID Global Corporation X001800D Manuale Utente

© 

2010 

HID 

Global 

Corporation 

 

       All 

rights 

reserved 

 

This section describes the setup and installation for the DTC4500 Card Printer.  

Follow these guidelines: 

•  Place the unit in a location with adequate air circulation to prevent internal heat build up. 
•  Use the Printer's dimensions as a guideline for the minimum clearances to the unit. (Note: Allow for 

adequate clearance in front of the unit to accommodate the unit with its Covers open.) 

•  Do not install unit near heat sources such as radiators or air ducts or in a place subject to direct 

sunlight, excessive dust, mechanical vibration or shock.    

If the unit is brought directly from a cold to a warm location or is placed in a very damp room, moisture 
may condense inside the unit. Should this occur, print quality may not be optimum.  

Leave the unit turned Off in a warm, dry room for several hours before using. This will allow the moisture 
to evaporate.    

  Caution: For safety purposes, Ethernet is not intended for a direct connection outside of the 

building. 

While unpacking your Printer, inspect the carton to ensure that no damage has occurred during shipping. 
Make sure that all supplied accessories are included with your unit.    

Check that the following items are included: 

• Power 

Supply 

•  US / EU Power Cable  
•  USB cable (2.0)   
•  Software Installation CD/User Guide 
• User 

Guide 

•  Warranty Statement, Registration Card and Compliancy Document 

 

DTC4500 Card Printer/Encoder User Guide

 

16