HID Global Corporation X001800D Manuale Utente
©
2010
HID
Global
Corporation
All
rights
reserved
Section 8: Cleaning
The Card Printer is built to require a minimum amount of maintenance. Nevertheless, there are a few
procedures you can perform on a regular basis or as needed to ensure the best possible performance
procedures you can perform on a regular basis or as needed to ensure the best possible performance
Safety Messages (review carefully)
Symbol
Critical Instructions for Safety purposes
Danger:
Failure to follow these installation guidelines can result in
death or serious injury.
death or serious injury.
Information that raises potential safety issues is indicated by a
warning symbol (as shown to the left).
warning symbol (as shown to the left).
• To prevent personal injury, refer to the following safety
messages before performing an operation preceded by this
symbol.
symbol.
• To prevent personal injury, always remove the power
cord prior to performing repair procedures, unless otherwise
specified.
specified.
•
To prevent personal injury, make sure only qualified
personnel perform these procedures.
personnel perform these procedures.
Caution:
This device is electrostatically sensitive. It may be
damaged if exposed to static electricity discharges.
damaged if exposed to static electricity discharges.
Information that raises potential electrostatic safety issues is
indicated by a warning symbol (as shown to the left).
indicated by a warning symbol (as shown to the left).
• To prevent equipment or media damage, refer to the
following safety messages before performing an operation
preceded by this symbol.
preceded by this symbol.
• To prevent equipment or media damage, observe all
established Electrostatic Discharge (ESD) procedures while
handling cables in or near the Circuit Board and Printhead
Assemblies.
handling cables in or near the Circuit Board and Printhead
Assemblies.
• To prevent equipment or media damage, always wear an
appropriate personal grounding device (e.g., a high quality
wrist strap grounded to avoid potential damage).
wrist strap grounded to avoid potential damage).
• To prevent equipment or media damage, always remove
the Ribbon and Cards from the Printer before making any
repairs, unless otherwise specified.
repairs, unless otherwise specified.
•
To prevent equipment or media damage, take jewelry off
of fingers and hands, as well as thoroughly clean hands to
remove oil and debris before working on the Printer.
of fingers and hands, as well as thoroughly clean hands to
remove oil and debris before working on the Printer.
DTC4500 Card Printer/Encoder User Guide
94