Teledesign Systems Inc TS4000EH Manuale Utente

The configuration program is used to configure the TS4000 for operation.  
Configuring the TS4000 consists of independently configuring both the modem 
operation and the radio frequency channels.  The configuration program consists 
of controls and menus.  The controls set the configuration and test options.  The 
menus (line items at the top of the screen) execute program commands. 
 
In addition to configuring the TS4000, the configuration program provides access 
to AirTest (wireless modem test software), AirCalc (wireless range estimation), 
AirScan (frequency scanning), TS4000 firmware upgrade program (see Testing, 
Upgrading Firmware) and remote diagnostics (see Remote Diagnostics). 
 
 
The configuration program has on-line help that contains information on how to 
use the program and also detailed information on specific controls and menus.  
Help is accessed by selecting a command from the help menu, pressing the 
question button or pressing the F1 key. 
 
 

„ 

Personal computer using a 486 or faster 

„ 

Microsoft Windows 95 or later 

„ 

CD-ROM disk drive.  

 
 
1)  Put the CD-ROM in the PC. 
2)  Run the installation program. 
3)  Follow the installation instructions. 
 

Serial Cable 
To transfer configurations between the TS4000 and a PC, their serial ports must 
be connected together.  The serial cable used should be a standard straight 
through (i.e. pin 1 to pin 1, pin 2 to pin 2, etc) serial cable.  This is the same type 
of cable used to connect a PC to a standard phone modem (See Serial Port). 
 
Before configurations can be retrieved from and programmed into the TS4000 

the configuration program must connect to the 
TS4000.  To connect, select the Connect to 
Modem command from the Modem menu or 
press the Connect to Modem button.  
Connecting to the TS4000 puts it into 
program mode which is indicated by the Rx 
and Tx lights remaining on continuously. 
 
When connected to the TS4000 the 
configuration program may disable (lighter 
shade) some of the controls.  These disabled 

controls are options that are not available with that particular TS4000's version of 
firmware.  These controls are re-enabled when the connection is broken (using 
the Disconnect command from the Modem menu or the Disconnect button).