Hughes Network Systems HNS9101 Manuale Utente

 
Enable Antenna Pointing Display: This checkbox determines whether the 

Pointing Display comes up each time the Satellite IP Modem is booted. If the Modem 
is not moved between sessions, this option can be deselected to bypass the 

pointing state upon power up. However, if the Satellite IP Modem is moved, antenna 
pointing must be enabled to ensure optimum data throughput and performance. 
Enable Antenna Pointing Audio Signal: This checkbox, associated with the 

Antenna Pointing display, enables or mutes audio through your computer speakers 
during pointing. 
Switch GPS antenna: This radio button should be set to whatever type of GPS 
antenna is installed in your Satellite IP Modem, Internal or External. The External 
option should be selected only when using the optional external GPS antenna 

accessory. 
Select the Apply button to implement your modifications. 

; 

 

Whenever you modify any settings on the Advanced Network 

Settings screen, you must exit the Control Pad, exit the Launch Pad, 

and power the Satellite IP Modem off and then back on so that the 
new settings can take effect. 

 

The Bluetooth screen is limited to use with the Bluetooth interface. 
Note the following warnings before you attempt to modify the interface parameters:  

ƒ

 

Utilize this screen only if you are using the Bluetooth interface 

ƒ

 

direct entry of DNS information. Please consult your Bluetooth device 

vendor to confirm that DNS entry is possible with your device. 

ƒ

 

Ensure that your Bluetooth device supports LAN access profile. For 

configuration of  LAN access profile please refer to your Bluetooth device 
user manual. 

Bluetooth Device Address: System-assigned, display-only. 
Bluetooth Device Name: The default name is “Regional BGAN Satellite IP 

Modem.” Click on and select the current name field, enter the new name, then select 
the Change Name button to apply the new name. 
Discoverability: These radio buttons determine whether the Satellite IP Modem is 

discoverable or not discoverable by other devices using Bluetooth. The default 
setting is discoverable, which means that other Bluetooth devices can find the 

Satellite IP modem when they are in the same proximity. 
Bonding: These radio buttons that determine whether the Satellite IP Modem 
accepts bonding or does not accept bonding with other devices using Bluetooth. 
The default setting is accepts bonding (bonding may sometimes be referred to as 

Regional BGAN Satellite IP Modem User Manual 

25