Wi Lan Inc EB03 Manuale Utente

RF Station Configuration

JUL 2001 Rev 03

47

The RF Station Configuration menu enables you to choose the operating mode, run some tests and optimize 
the RF link. Four tests can be run from this menu: link monitor test, transmit test, receive test and RSSI test. 
You can optimize a link by setting the maximum remote distance to a remote and by controlling the rate of 
data throughput (throttling). You can also block a unit so that it cannot pass any data.

➧ 

1.

From the Main Menu, select RF Station Configuration and press 

. The RF Station 

Configuration menu is displayed.

Operating Mode

Four modes are available: Normal Mode, Receive Test, 
Transmit Test, and RSSI Test

RF Transmit Status

Determines if data transmissions through the unit will 
be blocked or passed

Link Monitor Period

Period determines the amount of test data that is used 
to test the link. The smaller the number, the larger the 
amount of test data and test data overhead. A non-
zero value starts the link monitor test

                     RF Station Configuration

    Operating Mode                        -> Normal Mode

    RF Transmit Status                       unblocked

    Link Monitor Period (0=OFF, 1-10000)     0

    Test Mode Timer Minutes (1-1000)         5

    Base Station Only Parameters

    Maximum Remote Distance                  5 Km

    Link Monitor Remote Station Rank         1

    Remote Station Only Parameters

    Throttle Enable                          off

    Throttle Level (1-100)                   10   (640 kps)

    Link Monitor/Output Power                Dynamic Output Power

    User Output Power Adjust Ceiling         -5  dB

    Signal Margin (6-31) dB                   6 

    Current Output Power Level Adjust        -21