Wi Lan Inc EB03 Manuale Utente
Radio Module Configuration
JUL 2001 Rev 03
77
Setting the Acquisition Code
An acquisition code is a unique code contained within the preamble of a transmitted message. Units search
the air for messages that begin with a particular acquisition code. Messages without the correct code are
treated as interference and are rejected by a unit. Messages with the correct code are accepted and
processed. Acquisition codes serve to isolate units from each other, especially when several units operate in
close proximity or at the same frequency in a multiple-sector or multi-cell environment. All units in the same
network must have the same acquisition code in order to communicate with each other.
the air for messages that begin with a particular acquisition code. Messages without the correct code are
treated as interference and are rejected by a unit. Messages with the correct code are accepted and
processed. Acquisition codes serve to isolate units from each other, especially when several units operate in
close proximity or at the same frequency in a multiple-sector or multi-cell environment. All units in the same
network must have the same acquisition code in order to communicate with each other.
➧
To set the acquisition code
1.
From the Main Menu, select Radio Module Configuration and press
Enter
. The Radio Module
Configuration menu is displayed.
2.
Select Acquisition Code and press
Enter
. The data field highlights.
3.
Type the Acquisition code (0-15).
4.
Press
Enter
. The new setting is displayed in the "New" column.
5.
Select Reboot New RF Configuration and press
Enter
. The unit reboots and the AWE 120-24
Login menu is displayed. The unit now runs using the "Current" acquisition code for the amount of time
specified by the Current Test Minutes.
specified by the Current Test Minutes.
6.
To save the current setting(s) to flash memory, log in, go to the Main Menu, and select Radio Module
Configuration,
Configuration,
Save Current Config to Flash. See
7.
Press
Esc
to exit to the Main Menu.
Radio Module Configuration
New Current Flash
Station Type Remote Unit Remote Unit Remote Unit
Station Rank (1-1000) 1 1 1
Center Frequency 2.4400 GHz 2.4400 GHz 2.4400 GHz
Security Password 1 (Hex) 1 1 1
Security Password 2 (Hex) 10 10 10
Security Password 3 (Hex) 100 100 100
Security Password 4 (Hex) 1000 1000 1000
Security Password 5 (Hex) 10000 10000 10000
Scrambling Code (Hex) 0 0 0
Acquisition Code (0-15) 0 0 0
Config Test Minutes (1-120) 30 30 30
Tx Power Level Adjust -> 0 dB 0 dB 0 dB
Base Station Only Parameters
Repeater Mode off off off
System Symmetry Type Asymmetric Asymmetric Asymmetric
Dynamic Polling Level (1-100) 1 1 1
Remote Station Only Parameters
Remote Unit RF Group (0-63) 0 0 0
Reboot New RF configuration Press Enter to Execute
Save Current Config to Flash Press Enter to Execute