Yaesu Musen Co. Ltd. 20311X50 Manuale Utente

 

FT-950 

Operating Manual 

Vertex Standard Co., Ltd. 

118

ACS:  Iambic keyer with ACS (Automatic Character Spacing) enabled. 
 
040 A1A R-REV 
Function: Selects the keyer paddle’s wiring configuration for the KEY jack on the rear 
panel. 
Available Values: nor/rEV 
Default Setting: nor 
nor: 

Tip = Dot, Ring = Dash, Shaft = Ground 

rEV: 

Tip = Dash, Ring = Dot, Shaft = Ground 

 
041 A1A CW AUTO 
Function: Enables/disables CW keying while operating on SSB. 
Available Values: OFF/50/On 
Default Setting: OFF 
OFF: 

Disables CW keying while operating on SSB. 

50: 

Enables CW keying only while operating SSB on 50 MHz (but not HF). 

On: 

Enables CW keying while operating on SSB (all TX bands). 

Note: This feature allows you to move someone from SSB to CW without having to 
change modes on the front panel. 
 
042 A1A BFO 
Function: Sets the CW carrier oscillator injection side for the CW mode. 
Available Values: USb/LSb/Auto 
Default Setting: USb 
USb: 

Injects the CW carrier oscillator on the USB side. 

LSb: 

Injects the CW carrier oscillator on the LSB side. 

Auto:  Injects the CW carrier oscillator on the LSB side while operating on the 7 

MHz band and below, and the USB side while operating on the 10 MHz band 
and up. 

 
043 A1A BK-IN 
Function: Sets the CW “break-in” mode. 
Available Values: SEni/FuLL 
Default Setting: SEni 
SEni (SEMI): The transceiver will operate in the semi break-in mode. The delay 

(receiver recovery) time is set via the Menu item “044 A1A DELAY”.