VTech Telecommunications Ltd 80-8584-00 Manuale Utente
9
If you already have a wired doorbell installed, follow the instructions below to install
your new IS7121 doorbell unit.
Follow Step 1 through Step 6 in Doorbell installation above.
Insert a cross-head screwdriver to the side of battery compartment on the right,
Insert a cross-head screwdriver to the side of battery compartment on the right,
then twist and lift to loosen the screw and the metallic plates. Using a wire, slide
one end of the metal part of the wire underneath the metallic plate, then twist
the screws to secure. Connect the other end to the transformer.
1.
2.
2.
Use another wire, slide one end of the metal part underneath the metallic plate
on the doorbell, then connect the other end to the Trans terminal of your chime/
buzzer unit of the wired doorbell.
3.
If you do not connect domestic power supply nor install AA batteries to the IS7121
doorbell, only the existing wired doorbell will ring when being pressed.
•
CAUTION
FCC ID: xxxxx-xxxx-xx
IC: xxxxx-xxxxxxxx
Rotate
to Left
Angle
Adjustment
Rotate
to Right
to Right
Transformer
Transformer
Option 1: Ring the front doorbell of the IS7121 and existing wired doorbell
simultaneously.
Option 2: Ring the rear doorbell of the IS7121 and existing wired doorbell
simultaneously.
Rear Trans
Front
CAUTION
FCC ID: xxxxx-xxxx-xx
IC: xxxxx-xxxxxxxx
Rotate
to Left
Angle
Adjustment
Rotate
to Right
to Right
Transformer
Chime/buzzer of wired doorbell
Chime/buzzer of wired doorbell
CAUTION
FCC ID: xxxxx-xxxx-xx
IC: xxxxx-xxxxxxxx
Rotate
to Left
Angle
Adjustment
Rotate
to Right
to Right
Transformer
Rear
Trans
Front
Installing the doorbell with an existing wired doorbell