DEI Headquarters Inc. NAH104 Manuale Utente
P. 6
User Guide
To put the system into Valet Mode
To put the system into Valet mode using the KEY (Ignition Valet Mode):
1. Insert the ignition key into the ignition switch. Within 10 seconds, turn the key 5 times
successively into the IGNITION/RUN and OFF positions.
2. The parking lights will flash three times.
3. Turn the ignition OFF.
4. The LED on the antenna will come ON solid to indicate that the vehicle has successfully
3. Turn the ignition OFF.
4. The LED on the antenna will come ON solid to indicate that the vehicle has successfully
entered Valet mode.
To put the system into Valet mode using the TRANSMITTER (Remote Valet Mode):
1. Press and hold
and
buttons simultaneously until the remote beeps once (2-
way) or until the parking lights flash 3 times (1-way). Release the buttons.
2. The LED on the antenna will come ON solid to indicate that the vehicle has successfully
entered Valet mode.
To put the system out of Valet Mode
To put the system out of Valet mode using the KEY (Ignition Valet Mode):
1. Insert the ignition key into the ignition switch. Within 10 seconds, turn the key 5 times
successively into the IGNITION/RUN and OFF positions.
2. The parking lights will flash twice.
3. Turn the ignition OFF.
4. The LED on the antenna will be OFF.
3. Turn the ignition OFF.
4. The LED on the antenna will be OFF.
To put the system out of Valet mode using the TRANSMITTER (Remote Valet Mode):
1. Press and hold
and
buttons simultaneously until the remote beeps twice (2-
way) or until the parking lights flash twice (1-way).
2. The LED on the antenna will be OFF.
To verify whether the system is in Valet Mode using the remote:
Do a status request (applies only for 2-way remote):
Do a status request (applies only for 2-way remote):
1. Press the
button. The remote will beep.
2. The LED of
and
will flash.
The system will warn you if someone attempts to remote start the vehicle while in Valet Mode:
1. The LED of
and
will flash
2. The parking lights will turn ON, turn OFF then flash twice.
Panic Mode
Note: Panic mode can only be activated if the horn has been adequately configured by the
installer.
installer.
In an emergency situation, you can activate panic mode by pressing and holding the
button
until the remote beeps (2-way) or until the parking lights start flashing and the horn starts honking
(1-way).
If the vehicle is under a remote start, the engine will shutdown automatically before setting off the
horn. You can stop the horn by pressing either the
(1-way).
If the vehicle is under a remote start, the engine will shutdown automatically before setting off the
horn. You can stop the horn by pressing either the
button, the
button or the
button.
Furthermore, the panic mode can be stopped by activating Valet Mode (page 5).
* Panic Mode will automatically shut down after 30 seconds.