B+B SmartWorx THINQ1 Manuale Utente
Configuring the SDS using a Web interface
Quatech SDS User’s Manual
Figure 58 - Port Status screen
Step
Procedure
Description
Step 1
Select the desired port.
Click on the port number.
Step 2
Press the Clear key to reset the selected
port.
port.
Pressing Clear lets you halt an
unresponsive communications link.
Use this procedure to free a com port
unresponsive communications link.
Use this procedure to free a com port
that locks up. Note that the data trying
to get through that port is lost and will
to get through that port is lost and will
need to be resent.
Running the Ping test
Step
Procedure
Description
Preliminary
Step
Click on Diagnostics from the selection
bar and then click on either of the Ping
Test selections from the left panel.
The Ping Test screen displays.
Figure 59 - Ping Test screen
Step
Procedure
Description
Step 1
Enter the IP address of a device that is
connected to the network.
Press Ping to run the test.
This can be a PC or other device.
Use the Ping test to verify connectivity
between the SDS and another device on
Use the Ping test to verify connectivity
between the SDS and another device on
the network as specified by the IP
address field.
Note: This utility is not intended to ping the
SDS from a PC, but for the SDS to ping a
SDS from a PC, but for the SDS to ping a
PC or other device. To ping the SDS from a
PC on the network, use the ping command
from a DOS command line.
from a DOS command line.
The Ping results screen displays.
Page 70
940-0183-151
March 2005