B+B SmartWorx WLNG1 Manuale Utente
Operate the All-in-One
24
Print
Print instructions
1.
Locate a clean, flat surface near the bar code for printing.
2.
Place the nose of the All-in-One against the surface. The All-in-One should rest at an angle of
about 7 degrees from vertical.
about 7 degrees from vertical.
3.
Move the All-in-One straight across the surface.
4.
When the print is finished, the green light will turn off and the All-in-One will emit a Hi tone.
CAUTION:
Maintain a relaxed wrist and hand posture and use low force when printing.
Printing tips
IMPORTANT:
Keep the printer wheel continuously in contact with the print surface while printing.
1
Print wheel
Hold the All-in-One so that the angle of the device to the surface is approximately 7 degrees.
Do not push hard on the surface; light pressure will result in better prints, especially with soft
packages.
packages.
Do not rotate your wrist. Rotating your wrist while printing can cause skipping or incomplete
prints.
prints.