Ka Wah Manufactory Limited 91927 Manuale Utente

Pagina di 2
Honda CR250R Motocross Bike featuring Ricky Carmichael
60-4353
What’s Included
Installing Batteries
You will need...
• Four AA batteries for the motorcycle
• One 7.2V rechargeable Ni-Cd or Ni-MH battery pack 
(not included)
• One battery charger (not included)
• One 9V battery for the transmitter (not included)
• Phillips screwdriver (not included)
Put AA Batteries in the Motorcycle
• Loosen the screw on the battery 
box cover, located on the seat of the 
motorcycle, and remove the cover.
• Take out the battery holder and 
insert four AA batteries, matching 
the polarity symbols (+ and -) 
marked inside.
• Replace the battery holder and 
cover, and then secure it with the 
screw.
Put Rechargeable Battery Pack in Motorcycle
• Loosen the screw on the battery 
compartment cover, located on the 
bottom of the motorcycle, and 
remove the cover.
• Place the battery pack in the 
compartment, attaching the battery 
pack’s white plastic connector to 
the motorcycle’s matching 
connector. Do not force them 
together. They only fit one way.
• Replace the cover and secure it with the screw.
Put Battery in the 
Transmitter
• Remove the battery 
compartment cover.
• Insert the battery in 
the transmitter, 
matching the polarity 
(+ and -) symbols 
marked inside.
• Replace the cover.
Installing the Antenna
• Route the loose end of the motorcycle’s antenna wire through the supplied antenna tube.
• Insert the tube securely into the motorcycle’s tube holder.
• Extend the transmitter’s antenna to its full length before driving the motorcycle. For maximum range, hold the transmitter 
with the antenna as high as possible and point it straight up.
• Retract the transmitter’s antenna when you are finished driving the motorcycle.
Step One
Step Two
Motorcycle 
 Transmitter 
 
Ricky Carmichael Action Figure
Display Stand 
 
  
Antenna Tube  
  Two 4-Way Wrenches
Three Allen Wrenches  
  
Owner’s Manual
Adjusting the Trim Controls
Adjust the trim controls to make the motorcycle drive properly. 
Throttle Trim
• Place your motorcycle on the display stand so the rear wheel does not 
touch the ground.
• Turn the transmitter and motorcycle on and pull the throttle trigger.
• If the rear wheel moves, turn the TRIM VOL F/R on the transmitter 
clockwise or counter-clockwise until the wheel stops.
Never use the throttle trim to make the motorcycle go.
Steering Trim
If your motorcycle does not drive in a straight line, turn the TRIM VOL ST left 
or right until your motorcycle moves in a straight line. Release the steering 
wheel before you make the adjustment.
Driving the Motorcycle
• Turn the motorcycle and transmitter on. The LED lights on the transmitter.
• Position the motorcycle straight and upright, holding the back of the seat and lifting the rear wheel 
off the ground.
• Pull the transmitter’s throttle trigger to full speed and release the motorcycle. 
Warning: Keep your fingers away from the spinning tire.
• When you finish driving, turn the motorcycle off first, and then turn the transmitter off. See Page 2 
for Driving Tips.
Transmitter Controls
• Throttle Trigger - Pull the trigger back toward the grip to move forward. Release the trigger to stop.
• Throttle Trigger Brake - The throttle trigger is used to slow the motorcycle down also. Push the 
trigger forward to apply the brake and reduce speed. 
• Steering Wheel - Steer the wheel left to go left. Steer the wheel right to go right. Release the wheel 
to go straight.
Step Three
Throttle Trigger
Steering
Wheel
LED
OFF/ON
Switch
9V Battery Chamber
Trim
F/R
Trim
ST
Trim Controls
TRIM VOL F/R - Adjusts 
the throttle so the 
motorcycle stops 
completely when you 
release the trigger. If the 
trim is not set properly, the 
motorcycle might continue 
to move forward when you 
release the trigger.
TRIM VOL ST - Adjusts 
the wheel alignment so 
the motorcycle drives in a 
straight line when you 
release the steering 
wheel.
Recreate all of your favorite Ricky 
Carmichael moves by adjusting the 
head, arms and legs, while racing at 
an impressive 20 m.p.h.!
Cool Stunts
• When driving at a medium or high 
speed, the motorcycle may raise 
the front tire off the ground if you 
drive on a surface that has small 
bumps or obstacles.
• To fish tail the motorcycle, start 
making a turn at a low speed. Then, 
immediately change the direction of 
the turn and increase the speed.
• You can perform jumps with your 
motorcycle off ramps eight inches 
high or less.
Hint: When transporting your motorcycle, do not pick it up by the driver’s head. Use both hands to support 
the motorcycle, one underneath the motorcycle and the other on the rear of the seat.