Ka Wah Manufactory Limited 92827 Manuale Utente

60-4349

Your transmitter requires one 9V battery (not supplied) for 

power. When the transmitter's range decreases, replace the 

battery.

1. Slide ON/OFF on the transmitter to OFF.

2. Slide the battery compartment cover in the direction of the 

arrow to remove it.

3. Place the battery in the transmitter as indicated by the 

polarity symbols marked inside.

4. Replace the cover.

Your vehicle requires either four AA batteries or one 6V 

rechargeable battery pack (neither supplied).

In the Vehicle
1. Slide OFF/ON on the vehicle to OFF.

2. Use a coin to turn the battery compartment latch in the 

direction of the arrow to open it. 

3. Use a coin to loosen the screw on the battery adapter 

cover, and remove the cover. Insert four AA batteries 

according to the polarity symbols marked inside. Replace 

the cover, securing it with the screw. Place the battery 

pack close to the latch and slide it in the direction of the 

arrow until it stops. When using a 6V rechargeable battery 

pack, place the battery pack in the compartment according 

to the polarity symbols (+ and –) marked inside. Close the 

latch, and slide the battery pack in the direction of the 

arrow until it stops.

4. Use a coin to turn the battery compartment's latch 

opposite from the arrow until it stops.

1. Use a coin to turn the battery compartment latch in the 

direction of the arrow to open it.

2. Slide the battery pack towards the latch and lift it to 

replace it with a new one. 

1. Slide ON/OFF on the vehicle and transmitter to ON. The transmitter's LED lights and the vehicle's headlights illuminate.

2. Use the transmitter's control levers to control the vehicle.

3. When you finish driving the vehicle, slide OFF/ON on the vehicle and the transmitter to OFF.

Wheel Alignment
If the vehicle does not drive in a straight line when you release the right control lever, adjust the wheel alignment control on the 

bottom of the vehicle. Turn the control toward L (left) if the vehicle is pulling to the right or toward R (right) if the vehicle is pulling to 

the left.

•

Push left to move left.

•

Release to go straight.

•

Push right to move right.

•

Push forward to move forward.

•

Release to stop.

•

Pull back to move reverse.

HORN — Press to 

sound the horn.

•

Vehicle

•

Transmitter

•

Battery box for AA batteries

The cone spins when the vehicle 

moves forward or backward.

Red light illuminates 

when the vehicle 

moves in reverse.

Exposed gears sway and 

the wheel rotate when the 

vehicle moves forward and 

backward.

Ailerons move side to side 

when the vehicle moves left 

and right.

Note: Do not touch the 

exposed gears and the cones 

when they are rotating.

60-4349.fm  Page 1  Tuesday, August 5, 2003  4:35 PM