Twinhead International Corporation T7M Manuale Utente
40
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. End users must follow the
specific operating instructions for satisfying RF exposure
compliance. To maintain compliance with FCC RF exposure
compliance requirements, please follow operation instruction as
documented in this manual.
forth for an uncontrolled environment. End users must follow the
specific operating instructions for satisfying RF exposure
compliance. To maintain compliance with FCC RF exposure
compliance requirements, please follow operation instruction as
documented in this manual.
The availability of some specific channels and/or operational
frequency bands are country dependent and are firmware
programmed at the factory to match the intended destination. The
firmware setting is not accessible by the end user.
frequency bands are country dependent and are firmware
programmed at the factory to match the intended destination. The
firmware setting is not accessible by the end user.
Declaration of Conformity
This device complies with part 15 of the FCC rules. Operation is
subject to the following conditions:
subject to the following conditions:
•
This device may not cause harmful interference
•
This device must accept any interference received, including
interference that may cause undesired operation.
interference that may cause undesired operation.
European Notice
CE Declaration of Conformity
For the following equipment: Tablet built-in 802.11a/b/g/n WLAN
module
module
Is herewith confirmed to comply with the requirements set out in the
Council Directive on the Approximation of the Laws of the Member
States relating to Electromagnetic Compatibility (2004/105/EC), Low-
voltage Directive (2006/95/EC) , the procedures given in European
Council Directive 1999/5/EC .
Council Directive on the Approximation of the Laws of the Member
States relating to Electromagnetic Compatibility (2004/105/EC), Low-
voltage Directive (2006/95/EC) , the procedures given in European
Council Directive 1999/5/EC .
The equipment was passed. The test was performed according to the
following European standards:
following European standards:
•
EN 300 328 V.1.4.1 (2003-04)