Everspring Industry Co Ltd ST814 Manuale Utente

Pagina di 8
 
8
* COMMAND_CLASS_MANUFACTURER_SPECIFIC 
* COMMAND_CLASS_SENSOR_MULTILEVEL 
* COMMAND_CLASS_MULTI_INSTANCE_V2 
* COMMAND_CLASS_ALARM 
 
Troubleshooting 
 
Symptom Possible 
Cause 
Recommendation 
LED cannot be displayed
1.  Run out of battery 
power. 
2.  Check if reverse 
battery polarity 
1.  Replace a new battery 
2.  Refit the battery with 
correct polarity 
Temperature/humidity 
reading is incorrect 
The Detector is out of 
order 
1.  Please leave the detector 
without operating or do any 
setting for a period 
2.      Do not open the detector; 
send it to the local retailer.
 
Specifications* 
 
Operating Frequency 
908.42 MHz (US) / 869 MHz (RU) 
Operating Temperature Range 
-10°C - 50°C 
Relative Humidity Range 
20% - 90% 
Temperature Unit 
°C / °F 
Battery Type 
1.5V x 3 Alkaline/AA type battery 
Battery Life 
1.2 years** 
Operating Range 
Up to 30 meters line of sight (indoor) 
FCC ID 
 
*Specifications are subject to change without notice                    
**10 
triggers 
per 
day 
      
 
 
 
 
 
A501112116R
     
   2013/09 
 
 
 
 
                                   
 
 
Federal Communication Commission Interference Statement 
 
This equipment has been tested and found to comply with the limits for a Class B 
digital device, pursuant to Part 15 of the FCC Rules.    These limits are designed 
to provide reasonable protection against harmful interference in a residential 
installation.  This equipment generates, uses and can radiate radio frequency 
energy and, if not installed and used in accordance with the instructions, may 
cause harmful interference to radio communications.  However, there is no 
guarantee that interference will not occur in a particular installation.  If this 
equipment does cause harmful interference to radio or television reception, 
which can be determined by turning the equipment off and on, the user is 
encouraged to try to correct the interference by one of the following measures: 
Reorient or relocate the receiving antenna. 
Increase the separation between the equipment and receiver. 
Connect the equipment into an outlet on a circuit different from that to which 
the receiver is connected. 
Consult the dealer or an experienced radio/TV technician for help. 
 
This device complies with Part 15 of the FCC Rules. Operation is subject to the 
following two conditions: (1) This device may not cause harmful interference, 
and (2) this device must accept any interference received, including interference 
that may cause undesired operation. 
 
FCC Caution: Any changes or modifications not expressly approved by the party 
responsible for compliance could void the user's authority to operate this 
equipment. 
 
This transmitter must not be co-located or operating in conjunction with any 
other antenna or transmitter. 
 
 
WARNING: 
 
Do not dispose of electrical appliances as unsorted municipal waste, use 
separate collection facilities.   
 
Contact your local government for information regarding the collection systems 
available. 
 
If electrical appliances are disposed of in landfills or dumps, hazardous 
substances can leak into the groundwater and get into the food chain, damaging 
your health and well-being. 
 
When replacing old appliances with new ones, the retailer is legally obligated to 
take back your old appliance for disposal at least for free of charge.