DTC Communications Inc. PDTX5000A Manuale Utente
DTC COMMUNICATIONS, INC.
4
1
2
3
QUICK START
Palladium Transmitter
1 Connect the transmitter antenna to the SMA connector on the
Palladium unit (see photo left).
2 Attach a 12 VDC power source (such as a battery pack or AC power
adapter) to the power block as shown below. The input voltage range is
from 10 to 18 VDC.
from 10 to 18 VDC.
NOTE: Device is polarity sensitive. Connect DC power only as shown
below; black to black (-), red to red (+).
below; black to black (-), red to red (+).
3 Attach your camera video input (75 ohm composite video source in PAL
or NTSC) to the video RCA connector (see photo below).
4 Apply the necessary power to your camera and turn ON.
Complete these steps:
Programming
Connector
Connector
Thermal Issues
Palladium TX-5000A
Modules feature a heat sink
for proper heat dissipation.
For optimal performance, do
not block air flow over the
fins of this heat sink.
Modules feature a heat sink
for proper heat dissipation.
For optimal performance, do
not block air flow over the
fins of this heat sink.
Heat Sink