HeathCo LLC 60WRC02TX Manuale Utente
DRAFT COPY
© 2003 DESA Specialty Products™
598-1145-00
Multi-Channel
Remote Control
Features
• Operational range of up to 100 feet.
• Controls all Heath
• Controls all Heath
®
/Zenith Remote Home™ products.
• FCC/IC tested and approved.
• Flash control on compatible receivers when using the Panic
• Flash control on compatible receivers when using the Panic
feature.
Battery Cover
Two AAA
Batteries (Not
Included)
Installing 2-AAA Batteries
ALL ON
ALL OFF
OFF
DIM
PANIC
A
B
ON
GROUP
(Dip Switch 4 in
DOWN position)
(Dip Switch 4 in
UP position)
1 2 3
1 2 3
1 2 3
1 2 3
1 2 3
1 2 3
1 2 3
1 2 3
A
B
Setting Receiver(s) Dip Switches
The Control Panel transmitter has
preprogrammed dip switch settings for each
channel. In order for the Control Panel to
communicate with a receiver, the dip
switches on the receiver must correspond
with the preprogrammed dip switch settings
of the channel you wish to use.
preprogrammed dip switch settings for each
channel. In order for the Control Panel to
communicate with a receiver, the dip
switches on the receiver must correspond
with the preprogrammed dip switch settings
of the channel you wish to use.
Note:
There
are no dip switches on the Control Panel
that require setting.
1.
that require setting.
1.
Determine which receiver(s) will be
operated by which channel.
operated by which channel.
2.
Set receiver(s) dip switches 1, 2, and 3
to match the dip switch settings for the
channel you wish to operate the
receiver(s).
to match the dip switch settings for the
channel you wish to operate the
receiver(s).
3.
Determine whether the receiver(s) will
be in Group A or B.
be in Group A or B.
4.
Set dip switch 4 on the receiver to the
same setting as Group A or B.
same setting as Group A or B.
Preprogrammed Dip Switch
Settings for Remote Control
(Included on Back of Product
as a Reference)
Battery Installation
The Multi-Channel Remote Control is de-
signed for 3 Volt operation:
1.
signed for 3 Volt operation:
1.
Remove battery cover on rear of hous-
ing by pushing clip and lifting up.
ing by pushing clip and lifting up.
2.
Install 2-AAA batteries (not included)
according to polarity markings.
according to polarity markings.