EMCEE Broadcast Products MBSR100MW Manuale Utente
EMCEE MBSR100MW Installation Instructions
Page 3
DANGER
WATCH FOR
WIRES
You can be KILLED!
If this product comes near
electric power lines.
©2007 EMCEE Communications
Choose a transmit antenna that will provide the best coverage pattern for the
shadowed area to be served.
SERVICING the SYSTEM
There are no internal user adjustments or user serviceable parts inside the unit.
Do not disassemble the unit; the Warranty will be void if the unit is opened. If
either module does not properly function, return it to the factory for repair or
replacement.
UNPACKING the SYSTEM
Remove the power supply, then insert a finger into the finger hole of the inner
carton liner, lift to expose unit and accessories.
Remove the “L-Screw” from the mounting bracket and
replace the bracket as shown. Install the power supply
indoors close to an available AC outlet. Use a good quality
RG-6 cable (min.) to connect the power supply between
module power input and the power inserter.
ATTACHING MODULES to the ANTENNA MAST
Mount the modules with the connectors facing down. Slide
the mounting clamp into the indentations on the housing and
up into place. Hand-Tighten the “L-Screw” to secure the
module to the antenna mast or tower leg. DO NOT use a
wrench or pliers to tighten the “L-Screw”. Mast or tower leg
size can be 1” to 2-1/2”.
CONNECTING THE MODULES
Connect the antenna output connector to the RF Input ‘N’ connector on the pre-
amp module. Connect the RF inter-connecting cable ‘N’ connector to the ‘N’ jack
marked RF output. Connect the RF inter-connecting cable ‘N’ connector to the
RF input connector of the post-amp module.
shadowed area to be served.
SERVICING the SYSTEM
There are no internal user adjustments or user serviceable parts inside the unit.
Do not disassemble the unit; the Warranty will be void if the unit is opened. If
either module does not properly function, return it to the factory for repair or
replacement.
UNPACKING the SYSTEM
Remove the power supply, then insert a finger into the finger hole of the inner
carton liner, lift to expose unit and accessories.
Remove the “L-Screw” from the mounting bracket and
replace the bracket as shown. Install the power supply
indoors close to an available AC outlet. Use a good quality
RG-6 cable (min.) to connect the power supply between
module power input and the power inserter.
ATTACHING MODULES to the ANTENNA MAST
Mount the modules with the connectors facing down. Slide
the mounting clamp into the indentations on the housing and
up into place. Hand-Tighten the “L-Screw” to secure the
module to the antenna mast or tower leg. DO NOT use a
wrench or pliers to tighten the “L-Screw”. Mast or tower leg
size can be 1” to 2-1/2”.
CONNECTING THE MODULES
Connect the antenna output connector to the RF Input ‘N’ connector on the pre-
amp module. Connect the RF inter-connecting cable ‘N’ connector to the ‘N’ jack
marked RF output. Connect the RF inter-connecting cable ‘N’ connector to the
RF input connector of the post-amp module.