Horizon Hobby LLC SPMA3185 Manuale Utente

5

IMPORTANT: The installed receiver has been 
programmed for operation specifi cally in this 
aircraft.

To operate the SAFE

®

 system in this aircraft, set up your 

optional DSM2

®

/DSMX

®

 transmitter using the chart below.

- SAFE Flight mode is selected using Channel 5 
signal (high, middle, low)

- Panic Recovery mode is selected with Channel 6 
signal (high, low)

IMPORTANT: A transmitter with a 2-position 
Channel 5 switch will only allow the use of 
position 0 or position 2 fl ight modes. If possible 
assign Channel 5 in your transmitter to a 
3-position switch to operate all 3 fl ight modes 
(refer to your transmitter manual).

Refer to your transmitter’s manual for more information about transmitter setup. 

Throttle, Aileron, Elevator and Rudder in Normal 
Position

DX4e 
(2pos switch)

ACT/AUX 
switch

Trainer Button

2 Pos Flight 
Mode

DX4e 
(3pos switch)

CH 5 
switch

Trainer Button

3 Pos Flight 
Mode

DX5e 
(2pos switch)

CH 5 
switch

Trainer Switch

2 Pos Flight 
Mode

DX5e 
(3pos switch)

CH 5 
switch

Trainer Switch

3 Pos Flight 
Mode

Start all transmitter programming with a blank model (do a model reset), then name the model. 

Set Dual Rates to:

HIGH 100%  

LOW 70%

DX6i

1. Go to the SETUP LIST MENU

2. Set MODELTYPE: ACRO         

3. Set REVERSE: Gear Channel   

4. Go to ADJUST LIST MENU

5. Set TRAVEL ADJ: Gear/Fmode (0)

…100%; Gear/Fmode  (1)† 40%

6. Set FLAPS: Norm 

…100; LAND †100

7. Set MIX 1: ACT; Gear 

„Gear ACT,  RATE D 0%; U + 100%,  SW MIX, TRIM INH

Resulting 
in: 

The Gear and Mix switches operate the 3 SAFE modes
Gear 0; Mix 0 = Beginner Mode
Gear 1; Mix 0 = Intermediate Mode
Gear 1; Mix 1 = Experienced Mode
The Flap switch operates Panic Recovery. 
Position 0, Panic Recovery off, Position 1 Panic Recovery on.

DX7S
DX8

1. Go to the SYSTEM SETUP

2. Set MODEL TYPE: AIRPLANE    

3. Set SWITCH SELECT: Change all to INH then TRAINER: AUX1, FLAP: GEAR

4. Go to the FUNCTION LIST

5. Set SERVO SETUP: Reverse AUX1
Resulting 
in: 

Flap/Gyro Switch operates the 3 SAFE modes (0 Beginner/1 Intermediate/2 Experienced) 
The Trainer/Bind button operates Panic Recovery

DX6e
DX6 G2, G3
DX7 G2
DX8 G2
DX9
DX18
DX20

1. Go to the SYSTEM SETUP

2. Set MODEL TYPE: AIRPLANE 

3. Go to CHANNEL ASSIGN: click NEXT to go to Channel Input Confi g:   Set GEAR: D 
 Set 

AUX1: 

i

4. Go to the FUNCTION LIST

5. Set SERVO SETUP: Reverse AUX1

Resulting 
in: 

Switch D operates the 3 SAFE modes (0 beginner/1 intermediate/2 Experienced) The Bind/I 
button operates Panic Recovery

®