Horizon Hobby LLC SPMA3185 Manuale Utente

9

Your T-28 Trojan S RTF transmitter comes pre-bound to the aircraft, so 
binding should not be necessary. 

Keep the aircraft and transmitter away from large metal objects, wireless 
sources or other transmitters while installing the battery.

CAUTION: Always disconnect the Li-Po fl ight battery from the 
aircraft receiver when not fl ying to avoid over-discharging the 

battery. Batteries discharged to a voltage lower than the lowest approved 
voltage may become damaged, resulting in loss of performance and 
potential fi re when batteries are charged.

CAUTION: Always keep hands away from the propeller. When 
armed, the motor will turn the propeller in response to any throttle 

movement.

For a list of compatible DSM2/DSMX transmitters, 
visit www.bindnfl y.com. 

1.  Refer to your transmitter’s unique instructions 

for binding to a receiver.

2.  Make sure the fl ight battery is disconnected 

from the aircraft.

3.  Ensure the transmitter is powered OFF.
4.  Connect the fl ight battery to the aircraft and 

turn the aircraft upright. The receiver LED will 
begin to fl ash (typically after 5 seconds).

5.  Make sure the transmitter controls are at 

neutral and the throttle is in the low position.

6.  Put your transmitter into bind mode.

7.  After 5 to 10 seconds, the receiver status LED 

will become solid, indicating that the receiver 
is bound to the transmitter. If the LED does not 
turn solid, refer to the Troubleshooting Guide at 
the end of the manual.

8.  Disconnect the fl ight battery and power the 

transmitter off.

For subsequent fl ights, power ON the transmitter 
for 5 seconds before connecting the fl ight battery.

The CG location is 30–32mm back from leading edge 
of the wing at the root. The battery cavity is oversized to 
allow for center of gravity adjustment. Start by placing the 
battery at the front of the cavity, and adjust as necessary.