Tyco Safety Products/Sensormatic AMS1080 Manuale Utente
AMS-1080 DETECTION SYSTEM
8200-0418-01, REV. A
INSTALLATION AND SERVICE GUIDE
1 of 18
AMS-1080
Detection System
Detection System
Installation and Service Guide
Contents
© 2004 Sensormatic
To the Installer
This installation and service guide explains how to
install, setup, and service the AMS-1080 detection
system.
install, setup, and service the AMS-1080 detection
system.
Parts required to install this system are:
- AMS-1080
- AMS-1080
Controller
- AMS-1080 Controller Mounting Kit
0352-0203-01 (optional)
- AMS-1080
Antenna(s)
- AMS-1080 Antenna Counter Mounting Kit(s)
0352-0199-01 or Pole Mounting Kit(s)
0352-0198-01
0352-0198-01
- ZKRANGER-DG Ranger antenna kits, as
required (purchase separately).
Other documents that may be required for
installation are:
- AMS-1080 Planning Guide, 8200-0418-02
- ZKRANGER-DG Ranger Installation Guide,
installation are:
- AMS-1080 Planning Guide, 8200-0418-02
- ZKRANGER-DG Ranger Installation Guide,
8200-0452-01
- AMS-1080 Theory or Operation, 8200-0418-03.
Note:
- Because
customer
requirements dictate the
placement of system components, your
Sensormatic representative will supply this
information separately.
Sensormatic representative will supply this
information separately.
- If this product was installed in a European
Union or European Free Trade Association
member state, please give the Declaration of
Conformity included with this product to the
manager or user. By law, this information must
be provided to the user.
member state, please give the Declaration of
Conformity included with this product to the
manager or user. By law, this information must
be provided to the user.
- The controller is cooled by a fan that is factory
set to 240Vac. If using 120Vac, remove the
cover from the controller and change fan
jumpers to 120Vac. See label inside the
controller for jumper locations.
cover from the controller and change fan
jumpers to 120Vac. See label inside the
controller for jumper locations.
- Install the AMS-1080 antenna at least 5cm (2in)
from metal surfaces.