Sangean Electronics U4 Manuale Utente

24

Your radio has a USB socket which is intended only for charging an iPhone or smart phone and 
similar devices. Charge time may vary and in some cases may take longer to charge than when 
using the manufacturers charging unit supplied with the smart phone.
1. Ensure your radio is switched off.
2. Connect your smart phone to the USB charging socket at the left side of your radio.
3. Your iPhone or smart phone will begin to charge.
4. Once your iPhone or smart phone has charged remove the USB lead.
Note: 
Do not use the USB charging if you want to charge the batteries, as the radio will fully charge the 
iPhone/Smartphone before you can charge the batteries.

The charger may not supply power to some USB devices.

When not using or after charging, remove the USB cable and close the cover.

 Do not connect a power source to the USB port. Otherwise there is a risk of fire. The USB port is 

only intended for charging lower voltage device. Always place the cover onto the USB port when 
not charging the lower voltage device.

 Do not insert a nail, wire, etc. into USB power supply port. Otherwise a circuit short may cause 

smoke and fire.

 Do not connect this USB socket with your PC USB port, as it is highly possible that it may cause 

breakdown of the units.

 Never use the USB socket in rainy or moist conditions to prevent moisture from entering the radio. 

Always keep the rubber cover on the back well closed under these conditions.