Azden Corporation 1200XT Manuale Utente
THE 1200XT TRANSMITTER
Powering the 1200XT Transmitter
The 1200XT uses two “AA” batteries for power. The batteries are
placed in the battery compartment by placing the batteries in the
compartment as shown in the illustration [
placed in the battery compartment by placing the batteries in the
compartment as shown in the illustration [
♠
]. When installing the
batteries, be sure to follow the correct polarity. DO NOT FORCE
THE BATTERIES INTO THE COMPARTMENT. Azden does not
recommend the use of rechargeable batteries.
THE BATTERIES INTO THE COMPARTMENT. Azden does not
recommend the use of rechargeable batteries.
Setting the Transmitting Frequency on the 1200XT
Before the 1200XT can be used, it and the associated receiver have
to set to the same frequency. This can be accomplished on the
1200XT transmitter by first setting the LCD display to one of two
views - ‘Frequency’ or ‘Channel’. To do this, after installing fresh
batteries, turn the 1200XT to the ON position [
to set to the same frequency. This can be accomplished on the
1200XT transmitter by first setting the LCD display to one of two
views - ‘Frequency’ or ‘Channel’. To do this, after installing fresh
batteries, turn the 1200XT to the ON position [
e
]. Next, using the tip
of a ballpoint pen, an unbent paper clip or something similar, press
the MODE button [
the MODE button [
j
] repeatedly until one of the two following
screens appears.
E. Display (continued)
life (from 1 to 3 segments) with 3 segments meaning maximum bat-
tery power. The bottom segment will blink when the battery power
falls to less than 2.2V and indicates that it is time to replace the bat-
teries. Azden recommends the use of Alkaline batteries only.
tery power. The bottom segment will blink when the battery power
falls to less than 2.2V and indicates that it is time to replace the bat-
teries. Azden recommends the use of Alkaline batteries only.
Across the top of the display, up to 5 segments will illuminate de-
pending on the strength of the transmitted audio signal - from 2 (weak)
to 5 (strong). The first (left) segment will light when the ST.BY switch
is turned to ON. The best audio is achieved when 4 to 5 segments
are lit. If all 5 segments are lit continually, the signal is too strong and
could overload the input of the receiver. Either move the microphone
further away from the sound source or reduce the microphone input
gain [
pending on the strength of the transmitted audio signal - from 2 (weak)
to 5 (strong). The first (left) segment will light when the ST.BY switch
is turned to ON. The best audio is achieved when 4 to 5 segments
are lit. If all 5 segments are lit continually, the signal is too strong and
could overload the input of the receiver. Either move the microphone
further away from the sound source or reduce the microphone input
gain [
♣
].
The display can also show the total number of hours of use (change
to this display using the MODE [
to this display using the MODE [
j
] button). To start, after choosing
the TIME mode, press the UP [
l
] button until the display shows
00:00. Then, each time the transmitter is turned ON the clock will
keep track of the total hours and minutes used. This is a handy way
of keeping track of battery life.
keep track of the total hours and minutes used. This is a handy way
of keeping track of battery life.
1
4
1
3
5
6
7
8
10
♣
♠