Azden Corporation 35BT Manuale Utente

Belt Clip

Important information
Licensing of this, or any Azden wireless equipment is the user’s responsibility. The ability to receive a license depends largely on the
user’s classification, application and frequency. Contact the appropriate agency (FCC in the US) for further information.

These devices comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) These devices may not
cause harmful interference, and (2) These devices must accept any interference received, including interference that may cause
undesired operation.

NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment.
Such modifications could void the user's authority to operate the equipment.

These devices and their antenna(s) must not be co-located or operated in conjunction with any other antenna or transmitter.

Operating the system

Because this is a frequency agile system, the receiver and transmitter must be on the same

TV:Receive/Transmit channel number. To change the channel number, use the tip of the

provided tool and press the UP or DOWN button to the desired channel. Make sure both

the receiver and transmitter are on the same channel.

305UPR Receiver

After installing new batteries, mount the receiver to your video camera with the supplied

shoe mount or hook & loop fastener. Select one of the supplied cables and connect the

output cable to the receiver and to the microphone input on the video camera. Switch the

305UPR to “ON” and the battery level indicator should come on. If it doesn’t, check the

batteries. When the 305UPR receives a signal from the transmitter the reception level

indicator will come on. If it does not, make sure both the receiver and transmitter are on

matching channels.

35BT Transmitter

Plug in the supplied lapel microphone and clip it to your subject. The microphone should be

placed 4-12 inches from your subject’s mouth. Clip the transmitter to a belt using the

supplied belt-clip or place it in a pocket. Switch the 35BT to “ON” and the battery level

indicator should come on. If it does not, check the battery. Have someone speak into the

microphone as you monitor the

sound through the receiver’s phone output. If the sound is

distorted lower the MIC input level on the transmitter. If there is not enough volume raise the

MIC input level on the transmitter.
35XT Transmitter

Switch the transmitter to “ON” and the battery level indicator should come on. If it does not,

check the battery. Have someone speak into the microphone as you monitor the sound

through the camera’s monitor output. If the sound is distorted lower the level control on the

transmitter. If there is not enough gain raise the level control on the transmitter.

35HT Transmitter

Switch the transmitter to “ON” and the battery level indicator should come on. If it does not,

check the battery. Have someone speak into the microphone as you monitor the sound

through the camera’s monitor output. If the sound is distorted lower the level control on the
transmitter. If there is not enough gain raise the level control on the transmitter.