Microsoft Corporation MN700 Manuale Utente
Chapter 1: Introduction 3
Filename: X0946803ch1.doc Project: H1_top
Template: BBN_A5_1col_ltr_fix.dot Author: ArleneR Last Saved By: S&T
Revision #: 5 Page: 3 of 8 Printed: 06/25/03 02:18 PM
Power, Modem, and
Wireless lights
Wireless lights
Ethernet port lights, which
correspond to the Ethernet
ports on the back of the
base station
correspond to the Ethernet
ports on the back of the
base station
Optional
stand
stand
Antenna
The front of the base station has seven status lights. The following table describes the
behavior of each light.
behavior of each light.
Status light
On
Off
Blinking
Power Green:
Ready
Orange: Resetting,
restoring factory defaults,
or upgrading firmware
restoring factory defaults,
or upgrading firmware
Not receiving
power
power
Error*
Modem
Modem connected and
turned on
turned on
Modem off or not
connected
connected
Data being sent or received
through the modem
through the modem
Wireless
Radio enabled
Radio disabled
Data being sent or received
wirelessly
wirelessly
Ethernet
port (4)
port (4)
Ethernet device
connected and on
connected and on
Ethernet device off
or not connected
or not connected
Data being sent or received
over Ethernet connection
over Ethernet connection
*If the Power light is blinking, reset the base station by using the procedure described
later in this chapter.
later in this chapter.