Digital Monitoring Products Inc 1100 Manuale Utente
INSTALLATION SHEET
1100 Receiver
Description
The 1100 Receiver provides 500 wireless zones for DMP Command Processor™ panels. The receiver and housing
easily mount near the panel enclosure or in a remote location. Providing a wide reception range, a fast scan time
of available frequencies, and two-way communication with transmitters, the 1100 Receiver is a simple and robust
solution to problematic hardwired systems. The 1100 Receiver is compatible with all DMP 1100 series devices.
easily mount near the panel enclosure or in a remote location. Providing a wide reception range, a fast scan time
of available frequencies, and two-way communication with transmitters, the 1100 Receiver is a simple and robust
solution to problematic hardwired systems. The 1100 Receiver is compatible with all DMP 1100 series devices.
Compatibility
The 1100 Receiver is compatible with the following panels.
• XR500
• XRSuper6
• XR20
• XR40
• XRSuper6
• XR20
• XR40
Installing the 1100 Receiver
Mounting in a Remote Location
Choose an optimum location to mount the receiver. Be sure to install the receiver no more than 1,000 feet from the
panel. Remove the cover from the plastic casing. Secure the casing back and printed circuit board (PCB) to the wall
in the desired location using the supplied screws. Snap the cover back on the unit.
Choose an optimum location to mount the receiver. Be sure to install the receiver no more than 1,000 feet from the
panel. Remove the cover from the plastic casing. Secure the casing back and printed circuit board (PCB) to the wall
in the desired location using the supplied screws. Snap the cover back on the unit.
FCC Note: The antenna(s) used for this transmitter must be installed to provide a separation distance
of at least 20 cm from all persons. It must not be co-located or operated in conjunction with any other
antenna or transmitter.
of at least 20 cm from all persons. It must not be co-located or operated in conjunction with any other
antenna or transmitter.
Figure 1: Receiver PCB and back case
Wiring
The 1100 Receiver easily interfaces with the XRSuper6, XR20, or XR40 Command Processor™ panels using the keypad
bus. On the XR500 Command Processor™ panel set J23 for wirelss operation and connect the 4-wire harness to J22.
bus. On the XR500 Command Processor™ panel set J23 for wirelss operation and connect the 4-wire harness to J22.