Honeywell International Inc. 8DL5801-1 Manuale Utente

BATTERY INSTALLATION
1.

Remove the cover by inserting the

blade of a small screw-driver into
the slot at the bottom of the case
and twisting.

Install the Lithium battery supplied

in the battery compart-ment,
observing correct polarity (see
Figure 2). Make sure the battery is
firmly seated.

Replace the cover (snap fit).

BATTERY CAUTION;

Risk of fire, explosion and burns. Do
not recharge, disassemble, heat

above 100

C, or incinerate. Dispose

of used batteries promptly. Keep away
from children.

5801-003-V0

LITHIUM

BATTERY

(ADEMCO 466)

Figure 2. 5801 (Cover Removed)

WALL-MOUNTING (OPTIONAL)
To wall-mount the unit, proceed as follows:
1.

Disengage the supplied wall mounting plate from the unit by sliding it along the

case back.

Attach the mounting bracket in the desired location with the hooks pointing

upward, using the two screws supplied. The word TOP is molded along the upper
edge of the plate.

Locate the keyhole slots on the back of the transmitter case onto the bracket’s

hooks, and secure by sliding the case downward, firmly.

SPECIFICATIONS
Size:

4” x 2-1/4” x 13/16”`

102mm x 57mm x 21mm

LED:

Flashes when unit transmits.

Battery:

3-volt Lithium. Use only ADEMCO 466, Duracell DL123A,

Panasonic CR123A, Sanyo CR123A.

REFER TO THE INSTALLATION INSTRUCTIONS FOR THE RECEIVER/CONTROL WITH WHICH
THIS DEVICE IS USED FOR WARRANTY INFORMATION AND FOR DETAILS REGARDING THE
LIMITATIONS OF THE ENTIRE ALARM SYSTEM.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference (2) This device must accept any
interference received, including interference that may cause undesired operation. The user shall
not make any changes or modifications to the equipment unless authorized by the Installation
Instructions or User's Manual. Unauthorized changes or modifications could void the user's
authority to operate the equipment.

ÊN6478V3ÇŠ

N6478V3 5/05 Rev. B

2 Corporate Center Drive, Suite 100

P.O. Box 9040, Melville, NY 11747