Honeywell International Inc. 8DL5805 Manuale Utente
2
REPLACING THE BATTERY
1.
Remove case back by using the blade of
a small screwdriver to pry it open.
2.
Remove old battery
3.
Place batter in case back locations
(see
diagram above). - NEGATIVE END
MUST FACE DOWN.
4.
To close, snap case front and back
together.
Important Note: Do not remove
Printed
Circuit Board.
SPECIFICATIONS
Unit Dimensions:
55mm x 37mm x 12.7mm
Battery:
55mm x 37mm x 12.7mm
Battery:
Maxell CR2032, Duracell DL 2032, or Varta
CR2032
FOR WARRANTY INFORMATION AND FOR DETAILS REGARDING THE LIMITATIONS OF THE
ENTIRE ALARM SYSTEM, REFER TO THE INSTALLATION INSTRUCTIONS FOR THE
RECEIVER/CONTROL WITH WHICH THIS DEVICE IS USED.
ENTIRE ALARM SYSTEM, REFER TO THE INSTALLATION INSTRUCTIONS FOR THE
RECEIVER/CONTROL WITH WHICH THIS DEVICE IS USED.
FCC ID: CFS8DL5805
165 Eileen Way, Syosset, New York 11791
Copyright © 1999 PITTWAY CORPORATION
THIS DEVICE COMPLIES WITH PART 15 OF FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING
TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE
MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE
UNDESIRED OPERATION.
TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE
MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE
UNDESIRED OPERATION.