Honeywell International Inc. 8DL5869-1 Manuale Utente

K5299V1  3/03 

 

 

The 5869 Holdup Switch/Transmitter is a finger-operated 

RF transmitting device used for activating a holdup signal 
at the security system control, and/or any other security 

application. The 5869 is typically mounted under a counter 

or money draw for inconspicuous operation.  When the 

transmitter is activated, it sends an RF signal to the control 
panel, which then sends a burglary alarm to the central 

station.   
Once the 5869 trigger (Figure 1) is activated, the supplied 

reset key K4563 must be used to reset the device.  The 5869 

also contain tamper switches that are activated either when 
the cover is removed, or when the unit is forcibly removed 

from its installation location.   

The 5869 has a permanent serial number assigned during 
manufacture used for enrolling the 5869 with the security 

system control panel.  To enroll the 5869, refer to the 

respective Security System Control Panel Installation and 
Setup Guide.     
   

5869-002-V1

MOUNTING

HOLE
(TYP.)

RESET

KEY

COVER

TAMPER

SWITCH

BREAKAWAY

TAMPER

SCREW

No. 6X3/4

COVER

3V

LITHIUM

BATTERY

COVER 
ATTACH

HOLE

COVER

ATTACH

HOLE

MOUNTING

SCREW (2)

No. 6X2

TRIGGER

+

ANTENNA

COVER

SCREW (2)

No. 6X1/2

COVER

SCREW (2)

No. 6X1/2

 

Mount the 5869 under a counter or money drawer for easy 

access by the cashier.  Refer to the figure and steps that 
follow for typical mounting installation.   
Before mounting the 5869 permanently, perform Go/No Go 
tests to verify adequate transmitter signal strength at desired 

Panel Installation and Setup Guide).   
1.  Install the battery into the battery holder observing 

correct polarity as shown in Figure 1.

  

 

2.  Position the case to the desired location and install one 

No. 6 x ¾ screw (supplied) at the breakaway tamper 
release hole as shown in Figure 2 .   

3.  Secure the cover to the case with the two screws (No 6 x 

1/2) as shown in Figure 2.   
IMPORTANT:  To prevent damage to the case, do not 
over tighten the cover screws.   

4.  Secure the case with the cover to its mounting location 

using the two screws (No. 6 x 2) supplied as shown in 

Figure 2.   

The 5869 Holdup Switch/Transmitter should be 

programmed as a 24-hour silent zone type.  Refer to the 
Security System Control Panel Installation and Setup 

Guide for programming instructions.   
NOTES:    
• 

During programming of the control panel, the 5869 
Holdup Switch/Transmitter should be treated as "RF" 

(i.e., supervised RF) Type.   

• 

The 5869 is one closed input loop zone (loop 1).   

IMPORTANT:  The case will be held in place by the 

tamper release tab once the cover and mounting screws 

are removed.  Exercise caution not to jar the case while 
replacing the battery, possibly breaking the Tamper 

breakaway tab.   

1.  Remove the screws securing the 5869 cover and case to 

its mounting location.   

NOTE:  Use care not to bend the antenna while 

attempting to remove or install the battery.   

2.  Remove faulty battery and dispose of properly.   

3.  Observing correct polarity, insert the battery into the 

battery holder as shown in Figure 2.   

4.  Re-install screws to secure cover and case as shown in 

Figure 2.